Genie Z-80, Z-60 manual Controls, Ground Control Panel

Page 9

First Edition · Third Printing	Operator's Manual

Controls

Ground Control Panel

1Boom down button

2Boom extend/retract buttons

3Boom up button

4Engine speed select button

5LCD screen control buttons

6Gasoline/LPG select button

7LCD readout screen

8Red Emergency Stop button

9Diesel models: Glow plug button

10Key switch for off/ground/platform selection

11Engine start button

12Auxiliary power button

13High speed function enable button

14Low speed function enable button

1520A circuit breaker for system circuit

16Alarm

17Platform level up/down buttons

18Jib boom up/down buttons

19Secondary boom up/extend and down/retract buttons

20Platform rotate left/right buttons

21Turntable rotate left/right buttons

Part No. 82258

Genie Z-80/60

7

Image 9

Contents Operator’s Manual Contact us ContentsDo Not Operate Unless Safety RulesTip-over Hazards Electrocution HazardsSafety Rules Collision Hazards Fall HazardsExplosion and Fire Hazards Component Damage HazardsDamaged Machine Hazards Bodily Injury HazardDecal Legend Ground Control Panel ControlsPlatform Control Panel 2221 Fundamentals Pre-operation InspectionPRE-OPERATION Inspection Pre-operation InspectionMaintenance Observe and ObeyCheck the Engine Oil Level Deutz F4L 913 Engine Engine oil viscosity requirements Check the Hydraulic Oil LevelScheduled Maintenance Check the BatteriesCheck the Engine Coolant Level Liquid Cooled Models At the Ground Controls Function TestsTest Emergency Stop Test the Machine FunctionsTest Auxiliary Controls Test the Tilt SensorTest the Operating Envelope At the Platform Controls Test the Steering models with 2 wheel steer Test the Steering models with 4 wheel steerTest the Drive Enable System Test Drive and BrakingTest the Oscillate Axle Oscillating axle-equipped models Test Limited Drive Speed Workplace Inspection Workplace InspectionStarting the Engine Operating InstructionsEmergency Stop Only use the machine as it was intendedAuxiliary Controls Operation from GroundOperation from Platform Engine Idle Select rpm Drive EnableTo Drive Regulated Generator if equippedCheck Engine Light Operating Envelope Indicator LightsStopping the Engine After Each UseDecal Inspection DecalsDecals Transport and Lifting Instructions Free-wheel Configuration for WinchingSecuring to Truck or Trailer for Transit Securing the ChassisSecuring the Platform Turntable Chassis Lifting Point Points Lifting Instructions80/60 Specifications80/60 Range of Motion +34