Genie Z-80, Z-60 manual Maintenance, Observe and Obey, Check the Engine Oil Level

Page 14

Operator's Manual

First Edition · Third Printing

 

 

 

 

Maintenance

Observe and Obey:

Only routine maintenance items specified in this manual shall be performed by the operator.

Scheduled maintenance inspections shall be completed by qualified service technicians, according to the manufacturer's specifications and the requirements specified in the responsibilities manual.

Maintenance Symbols Legend

The following symbols have been used in this manual to help communicate the intent of the instructions. When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the meaning below.

Indicates that tools will be required to perform this procedure.

Indicates that new parts will be required to perform this procedure.

Indicates that a cold engine is required before performing this procedure.

Check the Engine Oil Level

Maintaining the proper engine oil level is essential to good engine performance and service life. Operating the machine with an improper oil level can damage engine components.

Check the oil level with the engine off.

1Check the engine oil dipstick. Add oil as needed.

GM models:

Result: The oil level should be within the ADD and FULL marks on the dipstick.

Deutz models:

Result: The oil level should be within the two marks on the dipstick.

Perkins models:

Result: The oil level should be within the two notches on the dipstick.

GM 3.0L EFI Engine

Oil viscosity requirements

below 0° F / -17.8° C

5W-30

 

 

above 0° F / -17.8° C

10W-30

Only use engine oils labeled "For Gasoline Engines" by the American Petroleum Institute (API).

Units ship with 10W-30.

12

Genie Z-80/60

Part No. 82258

Image 14
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDecal Legend Damaged Machine HazardsBodily Injury Hazard Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionCheck the Engine Oil Level MaintenanceObserve and Obey Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Engine Coolant Level Liquid Cooled Models Scheduled MaintenanceCheck the Batteries Test Emergency Stop Function TestsAt the Ground Controls Test the Machine FunctionsTest the Operating Envelope Test Auxiliary ControlsTest the Tilt Sensor At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest the Oscillate Axle Oscillating axle-equipped models Test the Drive Enable SystemTest Drive and Braking Test Limited Drive Speed Workplace Inspection Workplace InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedOperation from Platform Auxiliary ControlsOperation from Ground To Drive Drive EnableEngine Idle Select rpm Regulated Generator if equippedStopping the Engine Operating Envelope Indicator LightsCheck Engine Light After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34