Genie Z-80, Z-60 manual Electrocution Hazards, Tip-over Hazards

Page 4

Operator's Manual

First Edition · Third Printing

 

 

 

 

SAFETY RULES

Electrocution Hazards

This machine is not electrically insulated and will not provide protection from contact with or proximity to electrical current.

Maintain safe distances from electrical power lines and apparatus in accordance with applicable governmental regulations and the following chart.

Voltage

 

Minimum Safe

Phase to Phase

Approach Distance

 

Feet

Meters

 

 

0 to 300V

Avoid Contact

 

 

 

300V to 50KV

10

3.05

 

 

 

50KV to 200KV

15

4.60

 

 

 

200KV to 350KV

20

6.10

 

 

 

350KV to 500KV

25

7.62

 

 

 

500KV to 750KV

35

10.67

 

 

 

750KV to 1000KV

45

13.72

 

 

 

Allow for platform movement, electrical line sway or sag and beware of strong or gusty winds.

Keep away from the machine if it contacts energized power lines. Personnel on the ground or in the platform must not touch or operate the machine until energized power lines are shut off.

Do not use the machine as a ground for welding unless the machine is equipped with the weld line to platform option and it is properly connected.

Tip-over Hazards

Occupants and equipment shall not exceed the maximum platform capacity.

Maximum platform capacity 500 lbs

227 kg

 

 

Maximum occupants

2

 

 

Do not raise or extend the boom unless the machine is on a firm, level surface.

Do not depend on the tilt alarm as a level indicator. The tilt alarm sounds in the platform only when the machine is on a severe slope.

2

Genie Z-80/60

Part No. 82258

Image 4
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsBodily Injury Hazard Damaged Machine HazardsDecal Legend Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceCheck the Engine Oil Level Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Batteries Scheduled MaintenanceCheck the Engine Coolant Level Liquid Cooled Models Function Tests At the Ground ControlsTest Emergency Stop Test the Machine FunctionsTest the Tilt Sensor Test Auxiliary ControlsTest the Operating Envelope At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest Drive and Braking Test the Drive Enable SystemTest the Oscillate Axle Oscillating axle-equipped models Test Limited Drive Speed Workplace Inspection Workplace InspectionOperating Instructions Starting the EngineEmergency Stop Only use the machine as it was intendedOperation from Ground Auxiliary ControlsOperation from Platform Drive Enable Engine Idle Select rpmTo Drive Regulated Generator if equippedOperating Envelope Indicator Lights Check Engine LightStopping the Engine After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Chassis Securing to Truck or Trailer for TransitSecuring the Platform Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34