Genie Z-80, Z-60 Engine Idle Select rpm, To Drive, Drive Enable, Regulated Generator if equipped

Page 26

Operator's Manual

First Edition · Third Printing

 

 

 

 

OPERATING INSTRUCTIONS

To Drive

1Press down the foot switch.

2Increase speed: Slowly move the drive/steer control handle in the direction indicated by the blue or yellow arrows.

Decrease speed: Slowly move the drive/steer control handle toward center.

Stop: Return the drive/steer control handle to center or release the foot switch.

Use the color-coded direction arrows on the platform controls and the drive chassis to identify the direction the machine will travel.

Machine travel speed is restricted when the boom is raised or extended.

Drive Enable

Light on indicates that the boom has moved past either circle-end wheel and the drive function is turned off.

To drive, push the drive enable button and slowly move the drive/steer control handle off center.

If the drive/steer control handle is not moved within two seconds of pushing the drive enable button, the drive function will not operate. Release and push the drive enable button again.

Be aware that the machine may move in the opposite direction that the drive and steer controls are moved.

Always use the color-coded direction arrows on the platform controls and the drive chassis to identify the direction the machine will travel.

Regulated Generator (if equipped)

To operate the generator, press the generator button. The indicator light will come on and the engine will continue to run.

Plug power tools into the power to platform GFCI outlet.

To turn off the generator, push the generator button. The indicator light will turn off.

Engine Idle Select (rpm)

Select the engine idle (rpm) by pressing the select button. The indicator light next to the current setting will be on.

·Rabbit and foot switch symbol: foot switch activated high idle

·Turtle symbol: low idle

·Rabbit symbol: high idle

24

Genie Z-80/60

Part No. 82258

Image 26
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDecal Legend Damaged Machine HazardsBodily Injury Hazard Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionCheck the Engine Oil Level MaintenanceObserve and Obey Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Engine Coolant Level Liquid Cooled Models Scheduled MaintenanceCheck the Batteries Test Emergency Stop Function TestsAt the Ground Controls Test the Machine FunctionsTest the Operating Envelope Test Auxiliary ControlsTest the Tilt Sensor At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest the Oscillate Axle Oscillating axle-equipped models Test the Drive Enable SystemTest Drive and Braking Test Limited Drive Speed Workplace Inspection Workplace InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedOperation from Platform Auxiliary ControlsOperation from Ground To Drive Drive EnableEngine Idle Select rpm Regulated Generator if equippedStopping the Engine Operating Envelope Indicator LightsCheck Engine Light After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34