Operator's Manual | First Edition · Third Printing |
|
|
|
|
FUNCTION TESTS
Test Limited Drive Speed
63 Press down the foot switch.
64Raise the primary boom to 10° above horizontal.
65Slowly move the drive control handle to the full drive position.
Result: The maximum achievable drive speed with the primary boom raised should not exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40 seconds.
66Lower the primary boom to the stowed position.
67Extend the primary boom 4 feet / 1.2 m.
68Slowly move the drive control handle to the full drive position.
Result: The maximum achievable drive speed with the primary boom extended should not exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40 seconds.
69Retract the primary boom to the stowed position.
70Raise the secondary boom to 10° above horizontal.
71Slowly move the drive control handle to the full drive position.
Result: The maximum achievable drive speed with the secondary boom raised should not exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40 seconds.
72Lower the secondary boom to the stowed position.
If the drive speed with the primary or secondary boom raised or the primary boom extended exceeds 1 foot / 30 cm per second, immediately tag and remove the machine from service.
Test Auxiliary Controls
73Push in the red Emergency Stop button to the off position to shut off the engine.
74Pull out the red Emergency Stop button to the on position.
75Press down the foot switch.
76Simultaneously press and hold the auxiliary power button and activate each function control handle, toggle switch or button.
Note: To conserve battery power, test each function through a partial cycle.
Result: All boom and steer functions should operate.
20 | Genie | Part No. 82258 |