Genie Z-80, Z-60 manual Transport and Lifting Instructions, Free-wheel Configuration for Winching

Page 30

Operator's Manual

First Edition · Third Printing

 

 

 

 

Transport and Lifting Instructions

Observe and Obey:

The transport vehicle must be parked on a level surface.

The transport vehicle must be secured to prevent rolling while the machine is being loaded.

Be sure the vehicle capacity, loading surfaces and chains or straps are sufficient to withstand the machine weight. See the serial plate for the machine weight.

Be sure the turntable is secured with the turntable rotation lock before transporting. Be sure to unlock the turntable for operation.

Free-wheel Configuration for Winching

Chock the wheels to prevent the machine from rolling.

2WD models: Release

the non-steer wheel

brakes by turning overDisengage the drive hub

disconnect caps.

4WD models: Release

the wheel brakes byEngage turning over all four

drive hub disconnect caps.

Be sure the winch line is properly secured to the drive chassis tie points and the path is clear of all obstructions.

Reverse the procedures described to re-engage the brakes.

Note: The pump free-wheel valve should always remain closed.

28

Genie Z-80/60

Part No. 82258

Image 30
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDamaged Machine Hazards Bodily Injury HazardDecal Legend Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionMaintenance Observe and ObeyCheck the Engine Oil Level Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsScheduled Maintenance Check the BatteriesCheck the Engine Coolant Level Liquid Cooled Models Test Emergency Stop Function TestsAt the Ground Controls Test the Machine FunctionsTest Auxiliary Controls Test the Tilt SensorTest the Operating Envelope At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest the Drive Enable System Test Drive and BrakingTest the Oscillate Axle Oscillating axle-equipped models Test Limited Drive Speed Workplace Inspection Workplace InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedAuxiliary Controls Operation from GroundOperation from Platform To Drive Drive EnableEngine Idle Select rpm Regulated Generator if equippedStopping the Engine Operating Envelope Indicator LightsCheck Engine Light After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring to Truck or Trailer for Transit Securing the ChassisSecuring the Platform Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34