Genie Z-80, Z-60 manual Platform Control Panel

Page 10

Operator's Manual

First Edition · Third Printing

 

 

 

 

CONTROLS

1

2

3

4

5

6

7

8

9

10

27

Platform Control Panel

1Platform rotate toggle switch

2Platform level toggle switch

3Platform Not Level indicator light

4Machine Not Level indicator light

5Lower Primary Boom indicator light

6not used

7Horn button

2625

8Generator button with indicator light (option)

9Auxiliary power button with indicator light

10Diesel models: Glow plug button with indicator light

11Engine start button with indicator light

12Drive select button with indicator lights:

Machine on incline symbol: Low range

operation for inclines

1524

Machine on level surface symbol: High range operation for maximum drive speed

13Steer mode select buttons with indicator lights

14Engine idle (rpm) select button with indicator lights:

·Rabbit & Foot Switch: foot switch activated high idle

·Turtle: low idle

·Rabbit: high idle

8

Genie Z-80/60

Part No. 82258

Image 10
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsBodily Injury Hazard Damaged Machine HazardsDecal Legend Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionObserve and Obey MaintenanceCheck the Engine Oil Level Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Batteries Scheduled MaintenanceCheck the Engine Coolant Level Liquid Cooled Models Test Emergency Stop Function TestsAt the Ground Controls Test the Machine FunctionsTest the Tilt Sensor Test Auxiliary ControlsTest the Operating Envelope At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest Drive and Braking Test the Drive Enable SystemTest the Oscillate Axle Oscillating axle-equipped models Test Limited Drive Speed Workplace Inspection Workplace InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedOperation from Ground Auxiliary ControlsOperation from Platform To Drive Drive EnableEngine Idle Select rpm Regulated Generator if equippedStopping the Engine Operating Envelope Indicator LightsCheck Engine Light After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Chassis Securing to Truck or Trailer for TransitSecuring the Platform Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34