Genie Z-80, Z-60 manual Damaged Machine Hazards, Bodily Injury Hazard, Decal Legend

Page 8

Operator's Manual

First Edition · Third Printing

 

 

 

 

SAFETY RULES

Damaged Machine Hazards

Do not use a damaged or malfunctioning machine.

Conduct a thorough pre-operation inspection of the machine and test all functions before each work shift. Immediately tag and remove from service a damaged or malfunctioning machine.

Be sure all maintenance has been performed as specified in this manual and the appropriate service manual.

Be sure all decals are in place and legible.

Be sure that the operator’s, safety and responsibilities manuals are complete, legible and in the storage container located in the platform.

Bodily Injury Hazard

Do not operate the machine with a hydraulic oil or air leak. An air leak or hydraulic leak can penetrate and/or burn skin.

Always operate the machine in a well-ventilated area to avoid carbon monoxide poisoning.

Decal Legend

Genie product decals use symbols, color coding and signal words to identify the following:

Safety alert symbol—used to alert personnel to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

Red—used to indicate the presence of an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Orange—used to indicate the presence of a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Yellow with safety alert symbol— used to indicate the presence of a potentially hazardous situation which, if not avoided, may cause minor or moderate injury.

Yellow without safety alert symbol—used to indicate the presence of a potentially hazardous situation which, if not avoided, may result in property damage.

Green—used to indicate operation or maintenance information.

6

Genie Z-80/60

Part No. 82258

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDecal Legend Damaged Machine HazardsBodily Injury Hazard Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionCheck the Engine Oil Level MaintenanceObserve and Obey Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Engine Coolant Level Liquid Cooled Models Scheduled MaintenanceCheck the Batteries Function Tests At the Ground ControlsTest Emergency Stop Test the Machine FunctionsTest the Operating Envelope Test Auxiliary ControlsTest the Tilt Sensor At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest the Oscillate Axle Oscillating axle-equipped models Test the Drive Enable SystemTest Drive and Braking Test Limited Drive Speed Workplace Inspection Workplace InspectionOperating Instructions Starting the EngineEmergency Stop Only use the machine as it was intendedOperation from Platform Auxiliary ControlsOperation from Ground Drive Enable Engine Idle Select rpmTo Drive Regulated Generator if equippedOperating Envelope Indicator Lights Check Engine LightStopping the Engine After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34
Top Page Image Contents