Genie Z-80, Z-60 manual Contents, Contact us

Page 2

Operator's Manual	First Edition • Third Printing

Important

Read, understand and obey these safety rules and operating instructions before operating this machine. Only trained and authorized personnel shall be permitted to operate this machine. This manual should be considered a permanent part of your machine and should remain with the machine at all times. If you have any questions, call Genie Industries.

Contents
	Page
Safety Rules	1
Controls	7
Pre-operation Inspection	10
Maintenance	12
Function Tests	15
Workplace Inspection	21
Operating Instructions	22
Decals	26
Transport and Lifting Instructions	28
Specifications	31
Contact us:
Internet: http://www.genielift.com
e-mail: techpub@genieind.com

Copyright © 2002 by Genie Industries

First Edition: Third Printing, October 2002

"Genie" and "Z" are registered trademarks of Genie Industries in the U.S.A. and many other countries.

These machines comply with

ANSI/SIA 92.5-1992.

Printed on recycled paper

Printed in U.S.A.

Genie Z-80/60

Part No. 82258

Image 2

Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsSafety Rules Fall Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDecal Legend Damaged Machine HazardsBodily Injury Hazard Controls Ground Control PanelPlatform Control Panel 2221 Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionCheck the Engine Oil Level MaintenanceObserve and Obey Check the Hydraulic Oil Level Deutz F4L 913 Engine Engine oil viscosity requirementsCheck the Engine Coolant Level Liquid Cooled Models Scheduled MaintenanceCheck the Batteries Test Emergency Stop Function TestsAt the Ground Controls Test the Machine FunctionsTest the Operating Envelope Test Auxiliary ControlsTest the Tilt Sensor At the Platform Controls Test the Steering models with 4 wheel steer Test the Steering models with 2 wheel steerTest the Oscillate Axle Oscillating axle-equipped models Test the Drive Enable SystemTest Drive and Braking Test Limited Drive Speed Workplace Inspection Workplace InspectionEmergency Stop Operating InstructionsStarting the Engine Only use the machine as it was intendedOperation from Platform Auxiliary ControlsOperation from Ground To Drive Drive EnableEngine Idle Select rpm Regulated Generator if equippedStopping the Engine Operating Envelope Indicator LightsCheck Engine Light After Each UseDecals Decal InspectionDecals Free-wheel Configuration for Winching Transport and Lifting InstructionsSecuring the Platform Securing to Truck or Trailer for TransitSecuring the Chassis Lifting Instructions Turntable Chassis Lifting Point PointsSpecifications 80/6080/60 Range of Motion +34