Invacare Ranger II250 SERIES Adjusting FLIP-UP Removable Footboard, Front Riggings Procedure

FRONT RIGGINGS PROCEDURE 3

This Procedure Includes the Following:

Adjusting Flip-Up Removable Footboard

Adjusting the Removable Footboard

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

ADJUSTING FLIP-UP REMOVABLE FOOTBOARD

NOTE:This footboard assembly is located on models built BEFORE 3/1/00. Refer to ADJUSTING THE REMOV- ABLE FOOTBOARD for the footboard assembly on models built AFTER 3/1/00 in this procedure of the manual.

NOTE: The following procedures are for both FWD and MWD wheelchairs, unless otherwise noted.

Angle (FIGURE 1)

NOTE: This procedure is for FWD wheelchair only.

NOTE: Angle availability is limited when the motors are in the forward-most position.

1.Remove the caplug caps.

2.Remove the front hex screw and caplug washer that secure the footboard mounting bracket and bushing to the wheelchair.

3.Repeat STEPS 1-2 for the opposite front hex screw and caplug washer.

4.Move the footboard mounting brackets to one (1) of three (3) positions.

NOTE: To ensure the existing hex screws tighten securely, apply Loctite 242 ® onto the threads.

5.Reinstall the two (2) hex screws and caplug washers through the two (2) footboard mounting brackets and bushings and into the wheelchair.

Wheelchair Frame

Bushing

Footboard

Caplug

Mounting

Washer

Bracket

Hex

Caplug Screw

Cap

FIGURE 1 - ADJUSTING FLIP-UP

REMOVABLE FOOTBOARD (ANGLE)

6.Torque the two (2) hex screws to 156-in/lbs.

7.Reinstall the two (2) caplug caps.

Height (FIGURE 2)

1.If necessary, remove the four (4) caplug caps.

2.Remove the hex screw, two (2) spacers, washers and locknut that secure one (1) of the footboard pivots to the footboard mounting bracket.

3.Repeat STEP 2 for opposite side of the wheelchair.

4.Move the footboard pivots to one (1) of the following:

MWD WHEELCHAIRS: one (1) of seven (7) positions.

FWD WHEELCHAIRS: one (1) of five (5) positions.

HEIGHT - FWD WHEELCHAIRS

		Footboard Mounting
		Bracket
Flip Up Footboard		Washer
	Hex
	Screw
Five (5)
Mounting
Positions
Caplug	Locknut
Cap		Footboard Pivot

HEIGHT - MWD WHEELCHAIRS

Footboard	Seven (7)
Mounting
	Mounting
Bracket
	Positions
Hex
Screw	Washer

Locknut
Footboard Pivot	Flip Up Footboard

FIGURE 2 - ADJUSTING FLIP-UP

REMOVABLE FOOTBOARD (HEIGHT)

Loctite - Registered Trademark of Loctite Corporation.

F R O N T

R

I

G G I N G S

15