Invacare Ranger II250 SERIES, Ranger IIJR Folding Battery Tray for Transport Figure

FWD WHEELCHAIRS	PROCEDURE 13
8. Pull end of retaining strap to secure front battery box	BATTERY TRAY
and front shroud in place.

9.Position the rear battery box onto the battery tray as shown in FIGURE 8.

10.Connect the battery cable from the rear battery box to the rear battery connectors on the wheelchair frame.

11.Bundle excess joystick cable and tie wrap together. See DETAIL "A".

12.Position excess joystick cable between retaining strap and rear battery box. See DETAIL "A".

13.Clip the rear retaining strap together.

14.Pull end of retaining strap to secure battery box and joystick in place.

15.Install the rear shroud. Refer to REMOVING/INSTALL- ING SHROUDS in PROCEDURE 9 of this manual.

DETAIL"A"
Joystick	Rear Battery
Cable	Box

Tie-Wrap		Retaining
			Strap
Rear Shroud	Retaining		Pull this end of
			retaining strap to
	Strap
			secure battery

box in place

Slot

Rear

Battery

Box

Battery			Retaining
	Battery	Front	Strap
Connections
on Side of	Tray	Battery	Front
Wheelchair		Box
Frame			Shroud

FIGURE 8 - INSTALLING/REMOVING BATTERY BOXES

R2JR

WARNING

Pinch point exists between battery tray and bat- tery bracket.

Folding Battery Tray for Transport (FIGURE 9)

1.If necessary, remove the front and rear shroud. Refer to REMOVING/INSTALLING SHROUDS - FWD WHEELCHAIRS in PROCEDURE 9 of this manual.

2.Remove the battery boxes from the wheelchair. Refer toINSTALLING/REMOVINGBATTERYBOXESinthis procedure of the manual.

3.Perform one (1) of the following:

A.FOR R2BASIC and R2STANDARD - Lift up on the pin side of the battery tray and rotate UP towards the battery tray pivot.

B.FOR R2JR - Lift up on the notched side of the bat- tery tray and rotate UP towards the battery tray pivot.

4.Fold the wheelchair. Refer to TRANSPORTING RANGER II FWD in this procedure of the manual.

Unfolding Battery Tray for Use (FIGURE 10)

1.Unfold the wheelchair. Refer to TRANSPORTING RANGER II FWD in this procedure of the manual.

2.Perform one (1) of the following:

A.FOR R2BASIC and R2STANDARD-

WARNING

Make sure pins of battery tray are secure in the mounting slots of the hanger bracket, otherwise injury or damage may result.

Rotate the pin side of the battery tray DOWN against the mounting slots on the hanger bracket.

B.FOR R2JR - Rotate the notched side of the battery tray and DOWN against the battery tray stop.

3.Install the battery boxes. Refer to INSTALLING/RE- MOVING BATTERY BOXES in this procedure of the manual.

4.If necessary install the front shroud. Refer to REMOV-

ING/INSTALLING SHROUDS - FWD WHEEL- CHAIRS in PROCEDURE 9 of this manual.

F

W

D

W

H

E

E

L

C H A I R S

51