Invacare Ranger IIJR Battery Clamp Method Figures 4, 5, Installing Battery Clamp Covers

PROCEDURE 12 BATTERIES

B A T T E R I E S

BATTERY CLAMP METHOD (FIGURES 4, 5 AND 6).

WARNING

The battery clamp of the POSITIVE (+) battery terminal/post MUST be mounted in the posi- tion shown in FIGURE 5, otherwise the battery box top cannot be installed properly.

1.Perform one (1) of the following:

A.If the battery clamp of the POSITIVE (+) battery terminal/post is NOT mounted in the orientation shown in FIGURE 5, perform the following:

●Loosen the hex nut that secures the battery clamptothePOSITIVE(+)batteryterminal/post.

CAUTION

When tightening the clamps, always use a box wrench. Pliers will “round off” the nuts. NEVER wiggle the battery terminal(s)/post(s) when tightening. The battery may become damaged.

●Remove the battery clamp from the POSI- TIVE (+) battery terminal/post.

●Reposition the battery clamp on the POSI- TIVE (+) battery terminal/post as shown in FIGURE 4.

●Securely tighten the hex nut that secures the battery clamp to the positive (+) battery terminal/post.

B.If the battery clamp on the POSITIVE (+) battery terminal/post is positioned as shown in FIGURE 4, proceed to STEP 2.

CORRECT ORIENTATION OF THE POSITIVE (+) BATTERY TERMINAL/POST BATTERY CLAMP

POSITIVE (+) Battery Terminal/Post

(Note position of battery clamp)

2.Install battery clamp covers onto battery cables as follows (FIGURE 5):

A.RED battery clamp cover onto RED battery cable.

B.BLACK battery clamp cover onto BLACK bat- tery cable.

NOTE: Only one (1) battery cable and battery clamp cover are shown for clarity. Both battery clamp covers install in the same manner.

INSTALLING BATTERY CLAMP COVERS

Battery Clamp	Battery Cable
Cover

FIGURE 5 - CONNECTING BATTERY CABLES -

BATTERY CLAMP METHOD

CAUTION

Whenconnectingthebatterycable/ringterminal(s) to the battery(ies) clamp(s), the battery cable(s) MUSTbe connected in the position shown in DETAIL “A”, otherwise damage may occur to the battery cable and/or battery clamp covers.

3. Connect battery cable(s) to battery(ies) terminal(s)/

post(s) as follows (DETAIL “A”):

A. NEGATIVE (-) BLACK battery cable/ring termi-

nal between the mounting plate and battery

clamp of NEGATIVE (-) battery terminal/post.

B. POSITIVE (+) RED battery cable/ring terminal be-

tween the mounting plate and battery clamp bat-

tery clamp of POSITIVE (+) battery terminal/post.

4. Secure the battery cable(s)/ring terminal(s) to the battery

clamp(s), BLACK to NEGATIVE (-) and RED to POSI-

TIVE (+), with exisitng hex screws. Securely Tighten.

(DETAIL “A”)

Hex

Nut

NEGATIVE (-) Battery

Terminal/Post and Battery Clamp

Group 22NF

Battery

5.	Verify battery cable ring terminal(s) are correctly installed
	and securely tightened.
6.	Slidebatteryclampcoversdownbatterycablesandonto
	battery terminals. (DETAIL “B”)
7.	Secure each terminal cap in place with a tie-wrap (Use
	tie-wraps 11-1/2-inches long). (DETAIL “B”)

NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s).

8. Install the battery box top(s).

FIGURE 4 - CONNECTING BATTERY CABLES -

BATTERY CLAMP METHOD

44