Invacare Ranger II250 SERIES A T, Bottom Half of Back Canes, Hole, Wheelchair, Washers Frame

SEAT FRAME PROCEDURE 6

11.Securely tighten back upholstery to the new top half of the back cane with the phillips screw and washer.

12.Repeat STEPS 2-11 for the opposite side of the wheel- chair, if necessary.

Bottom Half of Back Canes

1. Flip the armrests up and out of the way. Refer to US-

ING/ADJUSTING FLIP BACK ARMRESTS in PRO-

CEDURE 4 of the owner's manual, part number

12.Use Loctite 242 on the hex bolts and torque the hex bolts to 75-inch pounds.

13.Securely tighten back upholstery to the top half of the back cane with the phillips screw and washer.

14.Repeat STEPS 2-13 for the opposite side of the wheel- chair, if necessary.

HOLE	Top Half of
PAIR #	Back Cane

S E A T

F

1080722.

2. Remove phillips screw and washer that secure back

upholstery to the existing top half of the back cane.

5

4

Locknuts

R A M

3.	Slide the back upholstery up to expose the two (2) hex
	bolts, washers and locknuts.
4.	Remove the two (2) hex bolts, washers and locknuts
	that secure the top half of the back cane to the existing
	bottom half of the back cane.
5.	Remove the top half of the back cane from the existing
	bottom half of the back cane.

NOTE: If the back angle of the wheelchair is staying the same, note the position of the existing bottom half of the back cane(s) before removing from the wheelchair.

6.Remove the two (2) hex bolts, four (4) washers and two (2) locknuts that secure the bottom half of the back cane to the wheelchair.

7.Remove the existing bottom half of the back cane from the wheelchair.

NOTE: The existing insert will be reused.

8.Remove the insert from the existing bottom half of the back cane.

9.Install the insert into the new bottom half of the back cane and line up the mounting holes.

10.Install the new bottom half of the back cane onto the wheelchair at the position noted.

NOTE: If the back angle needs to be changed, refer to CHANGINGBACKANGLEinthisprocedureofthemanual.

11.Reinstall the two (2) hex bolts, four (4) washers and two (2) locknuts that secure the new bottom half of the back cane to the wheelchair.

WARNING

3Washers

2

1

Hex Bolts (Apply Loctite 242 and torque to 75-inch

pounds)

Bottom Half

of Back

Cane

Insert	Locknuts
	Washers
	Wheelchair
Washers	Frame

FIGURE 4 - REPLACING BACK CANES

E

The back canes MUST be tightened se- curely to the wheelchair frame BEFORE using the wheelchair, otherwise injury or damage may occur. Use Loctite 242 on the hex bolts and torque to 75-inch pounds.

23