5. Assembly
•Insert the lamp mount, with the burner in- stalled, into the lamp housing and tighten it with the screws (20.8).
•Put the lid down again. Plug in the contact plug as far as it goes and retighten the screws.
•Place the lamp housing in the incident light lamp housing receptacle (21.1) and fasten it with the clamping screw on the side.
•Connect the lamp housing to the power supply (22.1).
Fig. 21 Rear side of stand
1Incident light lamp housing receptacle
2Transmitted light lamp housing receptacle
312 V 100 W connection for transmitted light (symbol: )
4 12 V 100 W connection for incident light (symbol: | ) |
1
2 | 3 4 |
|
Fig. 20 106 z lamp housing (on the side, open)
1Cover raised
2Collector
312 V 100 W lamp or
gas discharge lamp in mount
4Reflector (mirror)
5, 6, 7 Adjusting screw for x-y reflector
8Fastening screw for lamp mount
9Socket for contact plug
1
2 | 4 |
5
3
6
7
8 9 8
Fig. 22 Rear side of the ebq 100 supply unit
1Lamp connection
1
25