,QVWDOOLQJD'LVSOD\8QLW
&RQQHFWLQJ0XOWLSOH8QLWV
When more than one unit is being used the connections must be repeated in mul- ti drop mode i.e. receive of all Display Units in the system is connected to the transmit of the computer and the ground is common to all devices.
The Serial In (White) wire is not needed in most applications.
Terminal Box | Terminal Box |
Red - Serial Out
Black - Ground
PC Serial Port
Connector
Display Unit | Display Unit |
Address Selection
Each Display Unit includes a network communication Eprom and address switch module. This module plugs into the keyboard connector socket adjacent to the power connector and enables you to set an address for the associated unit. When the Display Unit is powered up, it reads the network address from the switch module.
4 | 5 | 6 | 4 | 5 | 6 |
|
|
|
|
|
|
|
|
|
| ||||
3 |
| 7 | 3 |
| 7 |
|
|
|
|
|
|
|
|
|
| ||||
2 |
| 8 | 2 |
| 8 |
|
|
|
|
|
|
|
|
|
| ||||
1 | 0 | 9 | 1 | 0 | 9 |
| Power | ||
|
|
|
|
| Connector | ||||
|
|
|
|
|
| ||||
Most significant | Least significant |
|
|
| |||||
address bit | address bit |
|
|
| |||||
Addresses are set by setting the required values on the two rotary switches of the address module. An address can be any value between 01 and 99 and each display in the network should have a different address number.
The maximum number of displays that can be connected to a single PC Serial Port will depend on the type of display and baud rate used to transfer informa- tion.
BusinessPhone Call Centre Supervisor - Standard |
|
Installation Guide | 42 |
EN/LZT BS 102 063/S R2B