$GGLQJD1HZ'LVSOD\8QLW
$GGLQJD1HZ'LVSOD\8QLW
The parameters needed to set up a Display Unit are entered via the Add a New
Display Unit Dialog. The Dialog is accessed from the Display Unit Connection
Dialog by clicking the New button or by pressing Alt + N.
New Display Unit are added by setting the following parameters:
•Display Unit Name
•Display Unit Type
•Device (The device that the Display Unit is connected to)
•Baud Rate
•Display Unit Address
After all parameters have been correctly set the connection is added by clicking
OK
'LVSOD\8QLW1DPH
Each Display Unit must be assigned a unique name.
When adding a new Display Unit a warning will be displayed if you enter a name that is already in use. Once assigned a Display Unit name cannot be edited, if a new name is required then the original Display Unit connection should be delet- ed and a new connection with the new name established.
EN/LZT BS 102 063/S R2B
| BusinessPhone Call Centre Supervisor - Standard |
45 | Installation Guide |