Casio DT-X5 Series manual Connecting the AC Adaptor and Connecting to Computer

Connecting the AC Adaptor and Connecting to Computer

Use the AC adaptor sold separately from the Bridge Satellite Cradle/Bridge Basic Cradle for the power supply of the Bridge Satellite Cradle/Bridge Basic Cradle. Always make sure that the power is being supplied to the Bridge Satellite Cradle by the AC adaptor before performing any type of data communication operation with the Handheld Terminal. The Handheld Terminal draws the power via the Bridge Satellite Cradle/ Bridge Basic Cradle during data communication.

1.After making sure that the Bridge Satellite Cradle/Bridge Basic Cradle power switch is turned off, plug the AC adaptor into the AC adaptor jack on the back.

2.Next, plug the AC adaptor into a power outlet.

Power switch (OFF)

When using the USB port

3.After making sure that the Bridge Satellite Cradle/Bridge Basic Cradle and your computer are both turned off, remove the cap from the Bridge Satellite Cradle/ Bridge Basic Cradle connection ports, and then perform one of the following steps to connect to your computer.

Be sure to keep the Bridge Satellite Cradle/ Bridge Basic Cradle connection ports covered whenever you are not using them.

RS-232C Connection

•Connect an RS-232C cable (DT- 887AXA) to the RS-232C port (HA- A61IO only) of the Bridge Satellite Cradle. Connect the other end to your computer’s RS-232C port.

USB Connection

•Connect a USB cable (DT-380USB) to the USB port of the Bridge Satellite Cradle/Bridge Basic Cradle. Connect the other end to your computer’s USB port.

4.Turn on the power. This causes the Bridge Satellite Cradle/Bridge Basic Cradle power indicator lamp to light in red.

Power contacts

Power switch (ON)

POWER DATA LINE

System Status Indicator Lamp

Communication Indicator Lamp

(HA-A61IO only)

Power Indicator Lamp

E-51

DT-X5_E_P49_58.p65 51 04.7.14, 6:05 PM