Casio DT-X5 Series manual Using the Laser Scanner DT-X5M10E/DT-X5M10R only

Using the Laser Scanner (DT-X5M10E/DT-X5M10R only)

1.After turning on the power, position the laser scanner close to a bar code and then press the Trigger key (R or L).

2. The laser emits light and scans the bar code. If scanning is completed normally, Indicator 2 displays a green light and a buzzer sounds. Indicator 2 displays a red light when an error has occurred during reading.

Important!

•If you are unable to scan a bar code, try changing the angle at which the scanner is held or distance from the scanner to the bar code, and then try scanning again.

•This Handheld Terminal is capable of scanning bar codes at a distance of 0~ 400 mm. Furthermore, the distance at which scanning is possible may vary according to the symbology.

•The laser scanner models are not available in the USA and Canada.

E-36

DT-X5_E_P36_48.p65 36 04.9.2, 9:45 AM