8.Set the Tone/Pulse switch located on the end of the base to correct dialing mode. Please check with your local Phone Com- pany if uncertain of the type of service.
9.Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
Note: Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
HANDSET BATTERY INSTALLATION
The C4205 uses a 3.6Volt 600mAh NiMH rechargeable 3 cell (AAA Type) battery that is included with your unit.
Handset Battery must be connected before beginning initial charging
To Install a New Battery
1.Remove battery cover
2.Install new battery
3.Connect battery pack
4.Replace battery cover
5.Charge for 12 hours before first use
Handset Battery Charging
1.Place the handset in the base. The CHARGE LED on the base will light RED.
2.After the batteries are fully charged, check for dial tone by pressing TALK on the handset.
Battery
Connector
Battery
Pack Plug
Battery
Compartment
Cover
Installing and connecting battery
Note: The battery in the handset must be fully charged for 12 hours before using the tele- phone for the first time.
13