Clarity C4205 manual

Handset Ringer

Set the switch marked Ringer OFF/VIBE/ON located on the side of the handset. When VIBE is selected the handset will ring and vibrate when receiving an incoming call. The ringer switch must be set to ON or VIBE for the handset to ring.

NOTE: If both handset and base ringers are set to OFF, the visual ringer will flash to indicate there is an incoming call.

Headset Jack

You can use this telephone hands-free when you install a 2.5mm headset (purchased separately). To install, plug the headset into the HEADSET JACK at the top of the handset. While in headset mode, the volume of headset is controlled by the telephone and the handset’s earpiece and micro- phone are disconnected.

Ordering a Headset

In the event you wish to purchase a headset for your C4205, please contact Plantronics at 1-800- 544-4660 for location near you. We recommend using the Plantronics M110 or M130 headset.

Belt Clip

You may choose to use the optional belt clip with your handset.

1.To attach slide belt clip down onto groves. Press the tabs on the belt clip into the slots to attach.

2.To remove, lift one side of the belt clip with your thumbnail and push back.

Hearing Aid Compatibility

The handset has a special coil inside of it to couple the sound to hearing aids equipped with

16T-Switches/T-Coils.