SpectraLink 150 M3 MCU manual Connect Multi-Unit Systems, Connect Power

Page 31

SpectraLink Corporation

Link WTS Installation and Operation

Connect Multi-Unit Systems

Use the following procedure to connect multiple MCUs.

1.Mount the MCUs side by side.

2.Connect the IPC cable from the OUT Port of the first unit to the IN Port of the adjacent unit. Repeat until all units are connected, as shown in the following illustration.

Multi-Unit Link 150 MCUs

!Applications Interface (OAI) Telephony Gateway may be connected to the out port of the last unit.No IPC cable is connected to the IN Port of the first unit. An Open

Connect Power

1.Connect the power plug from the AC adapter to the jack labeled PWR on the MCU.

Part Number: 72-0075-01-C-W.doc

Page 20

Image 31

Contents Installation and Operation Trademark Information SpectraLink Corporation Link WTS Installation and Operation UL Information FCC Information Industry Canada IC Notice Warranty Support Program Customer Responsibilities Return Material Authorization Cleaning Tips for Wireless Telephones Table of Contents Site Certification System Administration Icons and Conventions Installation OverviewAbout This Document Questions?SpectraLink Corporation Link WTS Installation and Operation System Operation Link Wireless Telephone System OverviewSpectraLink Corporation Link WTS Installation and Operation Front Panel of the Link 150 M3 MCU Required Materials Site PreparationDetermine Location of MCU Run Cable for System Wire SpecificationsRun Cables to Base Station Locations Terminate Cable at Base Station Locations Pull CableMCU Prepare Demarc BlocksDedicated Line for Diagnostic Modem Multiple Power PairsTwo Wire Analog or Digital Interface Four Wire Digital Interface Assign and Program Ports Install Demarc BlocksSpectraLink Corporation Link WTS Installation and Operation Two Wire Analog or Digital Demarc Block Four Wire Digital Demarc Block Wire Connector B Survey Site Install Link Wireless Telephone SystemCheck Components Mount MCUs to Wall Install MCUsConnect MCU to Demarc Blocks Connect Multi-Unit Systems Connect PowerSet Switch Interface Type Switch Interface Line LEDs MCU Type Mount Base Stations on Dropped Tile Ceilings Install Base StationsMount Base Stations On Finished Ceilings Wire and Connect Outdoor Base Stations Install Outdoor Base StationsSet Up Diagnostic Modem Connect and Register Wireless TelephonesRegister Wireless Telephones Unregister Wireless Telephones Test Wireless Telephones Program Wireless Telephone FeaturesSite Certification Troubleshoot Error Codes System AdministrationTroubleshoot Phone Features Status LEDs Description Action 12345 Status LED CodesStatus Description Action LEDs Status Description Action LEDs Indicator Description Action Wireless Telephone Status Indicator MessagesDelete Old Wireless Telephone Replace a Wireless TelephoneRegister New Wireless Telephone Connect the Replacement MCU Clear Configuration on Replacement MCUReplace an MCU Replace a Base Station MCU ID Wireless Telephone Planning WorksheetBase Station Location Worksheet Select Alternate Spread Spectrum Sequence Appendix a Technical ParametersChange Companding Open Application Interface Appendix B Program Analog FeaturesDefining Macros Plan ProgrammingProgram Macro Codes Clear or Erase a Function Examples of ProgrammingTransfer Speed DialBefore Installing the OAI Telephony Gateway Mount Telephony Gateway to Wall OAI Telephony Gateway’s Front PanelInitial Test Connect the OAI Telephony Gateway to the MCU Assign a Function Key to OAI Telephony Gateway Connect the OAI Telephony Gateway to the Application ServerCertification Test LED IndexOAI