SpectraLink Corporation | Link WTS Installation and Operation |
13.6Connect the OAI Telephony Gateway to the Application Server
Using a standard
The OAI Telephony Gateway uses the following pins on the connector:
Pin
Function
2Data OAI Receives
3Data OAI Transmits
5Ground
If the application is up and running, the RD and SD LEDs on the front panel of the OAI Telephony Gateway should be lit or blinking, indicating that the OAI Telephony Gateway is sending and receiving data to or from the PC.
13.7 Assign A Function Key to OAI Telephony Gateway
To access the OAI application, the user presses FCN and an assigned number key. Follow these steps to assign a function key to inititate the OAI application.
1.Make sure a Link Wireless Telephone is registered to line 2. This is the only port with administration access.
2.With the system up and running and within range of a Base Station, move the Mode switch on the MCU to the ADMIN position.
3.Press START on the Wireless Telephone registered to line 2. You should hear a steady tone.
4.Press the FCN key followed by the key you want to assign for OAI access.
5.Press ##555, then press END. This assigns OAI to the specified key.
6.Return the MCU Mode switch to the NORM position.
Part Number: | Page 49 |