Topcom Butler 6040
8.2Handset priority
Normally, if you have more than one handset registered to your base, they all ring at the same time. However, you can set one of them to ring before the others, so that calls can always be answered at one handset first.
• | From the standby screen, press MENU then scroll | to Base settings and press OK. | |
• | Scroll | to Handset Priority and press OK. Display highlights All Handsets. Press OK | |
| to select All Handsets |
| |
• to make all handsets ring together. |
| ||
Or |
|
|
|
• | Scroll to Select Handset and press OK. Scroll or | to the handset you want to ring | |
| first. Press OK. |
| |
• | Scroll | or to select the number of rings at the handset before the other handsets | |
start ringing. Press OK to confirm.
8.3Line settings
8.3.1 Dial mode
There are two types of dialling mode:
1)DTMF/tone dialling (the most common)
2)Pulse dialling (for older installations)
•Press MENU then scroll to Base Settings and press OK. Scroll to Dial Mode and press OK.
•Press 
or 
to highlight Pulse or Tone and press OK to confirm.
8.3.2 Flash time
•Press MENU then scroll to Base Settings and press OK. Scroll to Recall Mode and press OK.
•Press 
or 
to highlight Recall 1 for short flash time (100ms) or Recall 2 for long flash time (250ms) and press OK to confirm.
8.3.3 Ring pulse alerting signal (RPAS) on/off
Then you have callerID, the network send a short ring signal as an alerting signal before sending the caller number. To avoid the telephone to ring during this first ring signal you have to set the RPAS inhibitation to off.
•Select Menu then scroll to Base settings and press OK
•Scroll 
to RPAS inhibition and press OK
•Select Off to disable the phone to ring during the first ring burst, or On to enable the ringing and press OK
•Press and hold Back to return to standby
ENGLISH
Topcom Butler 6040 | 21 |