Bluetooth
Setup headset
Before you begin, make sure that your Bluetooth enabled headset is not connected to any other Bluetooth device. Refer to your headset user's manual to learn how to search for or add new Bluetooth devices.
To pair and connect a headset:
1.Press the MENU softkey on the telephone base when it is not in use.
2.Press /VOL+ or
3.Press /VOL+ or
•If a device is already connected to the telephone base, Connected devs will be temp. disconnected displays. Press the OK softkey to temporarily disconnect the device and continue the pairing process.
4.Set your headset to discoverable mode.
5.Press the NEXT softkey on the telephone base to search for your headset.
6.Once the telephone base finds your headset, press the SELECT softkey.
7.Enter the PIN of your headset (the PIN for most Bluetooth devices is 0000), then press the NEXT softkey. The screen displays Headset setup complete and then Connect headset to base?
8.Press the YES softkey. When a device is successfully connected, Device connected to base, and 1 and/or 2 displays.
•When you already have two devices on the active devices list, press the YES softkey to connect to your paired headset. You are prompted to replace an existing device on the active devices list (page 18).
The pairing process may take up to one minute. If the pairing process fails, try again.
Page all HS
Intercom |
Bluetooth |
Select |
Setup cell |
Setup headset |
Active devices |
Select |
Pls set headset to discoverable mode
next
Searching
for headset
SELECT HEADSET
Mary’s Headset
Select
ENTER PIN
next
Headset setup
complete
Connect headset to base?
yes |
| no |
Device
connected
to base
15