VTech VT 9241 manual Data Port

Page 26

DATA PORT

Your VT 9241 has a convenient feature: a Data Port built into the Base Unit.This port provides an easy way to connect your fax machine, modem, or other tele- phone device for direct access to Line2.

The Data Port is a standard RJ-11 jack, and is located on the back of the Base Unit.

					DATA PORT
	RINGER
	LINE 1		LINE 2
HIGH	OFF	HIGH	OFF		L1/L2	L2
	LOW		LOW	9V DC	TEL.LINE	DATA PORT

The Data Port only provides access to Line2, so you must have an active line connected to the LINE2 input on the back of the VT 9241 Base. To use the Data Port for access to dial tone on Line2, simple connect a standard phone cord, with RJ-11 connectors, from the Data Port to your fax machine, modem, or other telephone device.

		DATA PORT
	RINGER
LINE 1	LINE 2
	TEL.LINE	DATA PORT
AC ELECTRICAL
OUTLET

NOTE:

While the Data Port is being used, accidental access of Line2 by the VT 9241 or extension phone shar- ing the same line may interrupt a fax, modem or data transmission.

Image 26

Contents Features IntroductionWall Mounting Bracket Base Unit Battery pack Handset Belt clip AC adapterParts Check List Important Safety Instructions Read and understand all instruc- tionsIf the product exhibits a distinct Change in performance Rbrctm SealReplacing the Handset Battery Spare Battery Charger To install the Spare Battery PackGetting Started Charge the Handset BATTER- IES Before USE. The batteriesNever install telephone wiring dur- ing a lightning storm Wall Mounting Handset Features Spare Batt LED Base Unit FeaturesPower LED Charge LEDRinger Switches OFF KEY Volume UP KEYVolume Down KEY TONE/PULSE SwitchOperating Instructions Making CallsAnswer a Call Mute FeatureTips on Usingthe VT 9241 Speak Erphone To PUT a Call on HoldFerence Calling Pressing the VOL UP or Down keysMaking or Answering a Call While YOU’RE Already on a Call From the Base UnitJoining a Conversation Press Hold on the HandsetPress the appropriate Line key on the Base Unit Using the Intercom If Your Phone Rings During AN Intercom Conversation Using the Intercom During a Phone CallTemporary Tone Feature Programming the Ringer TypePress PGM/MEM Turning OFF the RingersTo turn off the ringer on the Handset do the following Checking the RingerTo Change or Replace a Stored Number To Store a Number Into MemoryTo Speed Dial a Stored Number Storing a Pause in a Speed Dial NumberConference Calling Using RedialStoring a Redial Number in Memory Speed Dial Way Conference Calling Switching a Conference Call From Handset To Base UnitSwitching a Conference Call From Base Unit To Handset Ending One Side Or Entire Confer- ence CallChanging Channels Optional Headset Installation and Operating Instructions InstallationONE Inch Data Port Taking Care of Your TELE- Phone MaintenanceExcess water or cleaning solvents of any kind Electrical StormsPhone DOESN’T Work AT ALL Handset does not Ring When YOU Receive a CallCase of Difficulty No Dial ToneCommon Cure for Electronic Equipment YOU Hear Other Calls While Using Your PhoneBase does not Ring Your Caller Fades in and OUTWarranty Statement What does OUR Warranty not COVER? HOW does State LAW Relate to this WARRANTY?Canada Vtech Electronics FCC and IC RegulationsUnited States FCC PartIC Industry Canada This telephone is registered for use in CanadaOffice Power Requirements Technical SpecificationsTransmit Frequency Weight Receive FrequencyTable of Contents If Your Phone Rings During AN Intercom Conversation Issue 91-5073-10-00