VTech VT 9241 manual Wall Mounting

Page 9

WALL MOUNTING

The Wall Mount adaptor is designed to fit on standard Wall Mount plates.

1.Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular tele- phone jack and a standard electri- cal outlet (120V AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the Base. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.

2.Position the wall mount adapter on the Base. Line up the tabs on the wall mount adapter with the holes on the bottom of the Base. Snap the wall mount adapter firmly in place.

3.Mount the Base on the wall. Posi- tion the Base so the mounting studs will fit into the holes on the bottom of the Base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the Base down on the mounting studs until it locks into place.

4.Connect the telephone cord(s). The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack(s) on the bottom of the Base. Insert the other end of the plug into the wall jack(s).

5.Connect the power cord. Plug the DC connector into the DC jack at the rear of the Base Unit. Plug the AC power adaptor into an electri- cal outlet.

wooden stud

wallboard

MODE	TONE
DIAL	PULSE

9

Image 9

Contents Introduction FeaturesBase Unit Battery pack Handset Belt clip AC adapter Parts Check ListWall Mounting Bracket Read and understand all instruc- tions Important Safety InstructionsRbrctm Seal If the product exhibits a distinct Change in performanceReplacing the Handset Battery To install the Spare Battery Pack Spare Battery ChargerCharge the Handset BATTER- IES Before USE. The batteries Getting StartedNever install telephone wiring dur- ing a lightning storm Wall Mounting Handset Features Power LED Base Unit FeaturesSpare Batt LED Charge LEDVolume Down KEY OFF KEY Volume UP KEYRinger Switches TONE/PULSE SwitchMaking Calls Operating InstructionsTips on Usingthe VT 9241 Speak Erphone Mute FeatureAnswer a Call To PUT a Call on HoldMaking or Answering a Call While YOU’RE Already on a Call Pressing the VOL UP or Down keysFerence Calling From the Base UnitPress Hold on the Handset Press the appropriate Line key on the Base UnitJoining a Conversation Using the Intercom Temporary Tone Feature Using the Intercom During a Phone CallIf Your Phone Rings During AN Intercom Conversation Programming the Ringer TypeTo turn off the ringer on the Handset do the following Turning OFF the RingersPress PGM/MEM Checking the RingerTo Speed Dial a Stored Number To Store a Number Into MemoryTo Change or Replace a Stored Number Storing a Pause in a Speed Dial NumberUsing Redial Storing a Redial Number in Memory Speed DialConference Calling Switching a Conference Call From Base Unit To Handset Switching a Conference Call From Handset To Base UnitWay Conference Calling Ending One Side Or Entire Confer- ence CallChanging Channels Installation Optional Headset Installation and Operating InstructionsONE Inch Data Port Excess water or cleaning solvents of any kind MaintenanceTaking Care of Your TELE- Phone Electrical StormsCase of Difficulty Handset does not Ring When YOU Receive a CallPhone DOESN’T Work AT ALL No Dial ToneBase does not Ring YOU Hear Other Calls While Using Your PhoneCommon Cure for Electronic Equipment Your Caller Fades in and OUTWarranty Statement HOW does State LAW Relate to this WARRANTY? What does OUR Warranty not COVER?United States FCC and IC RegulationsCanada Vtech Electronics FCC PartThis telephone is registered for use in Canada IC Industry CanadaOffice Transmit Frequency Weight Technical SpecificationsPower Requirements Receive FrequencyTable of Contents If Your Phone Rings During AN Intercom Conversation 91-5073-10-00 Issue