VTech VT 9241 manual Spare Battery Charger, To install the Spare Battery Pack

Page 6

SPARE BATTERY CHARGER

Your VTech VT 9241 is equipped with a spare battery charger built into the Base Unit. The spare battery charger allows you to always have a charged battery available, should your Hand- set battery discharge during normal use.

To install the Spare Battery Pack:

1.Open the Base Unit battery com- partment.

2.Place the spare Battery Pack in the battery compartment. Make sure the metal contacts on the underside of the battery are aligned with charg- ing contacts in battery compart- ment.

3.Replace the battery compartment cover.

4.When the battery is installed prop- erly, the spare battery LED on the Base Unit will be illuminated.

5.The spare battery will be fully charged after 24 hours. Please note that the SPARE BATT LED will al- ways be illuminated when a spare battery is installed.

To order Battery Packs and Headsets, call VTech Communications at 1-800-595-9511.

Image 6

Contents Features IntroductionBase Unit Battery pack Handset Belt clip AC adapter Parts Check ListWall Mounting Bracket Important Safety Instructions Read and understand all instruc- tionsIf the product exhibits a distinct Change in performance Rbrctm SealReplacing the Handset Battery Spare Battery Charger To install the Spare Battery PackGetting Started Charge the Handset BATTER- IES Before USE. The batteriesNever install telephone wiring dur- ing a lightning storm Wall Mounting Handset Features Spare Batt LED Base Unit FeaturesPower LED Charge LEDRinger Switches OFF KEY Volume UP KEYVolume Down KEY TONE/PULSE SwitchOperating Instructions Making CallsAnswer a Call Mute FeatureTips on Usingthe VT 9241 Speak Erphone To PUT a Call on HoldFerence Calling Pressing the VOL UP or Down keysMaking or Answering a Call While YOU’RE Already on a Call From the Base UnitPress Hold on the Handset Press the appropriate Line key on the Base UnitJoining a Conversation Using the Intercom If Your Phone Rings During AN Intercom Conversation Using the Intercom During a Phone CallTemporary Tone Feature Programming the Ringer TypePress PGM/MEM Turning OFF the RingersTo turn off the ringer on the Handset do the following Checking the RingerTo Change or Replace a Stored Number To Store a Number Into MemoryTo Speed Dial a Stored Number Storing a Pause in a Speed Dial NumberUsing Redial Storing a Redial Number in Memory Speed DialConference Calling Way Conference Calling Switching a Conference Call From Handset To Base UnitSwitching a Conference Call From Base Unit To Handset Ending One Side Or Entire Confer- ence CallChanging Channels Optional Headset Installation and Operating Instructions InstallationONE Inch Data Port Taking Care of Your TELE- Phone MaintenanceExcess water or cleaning solvents of any kind Electrical StormsPhone DOESN’T Work AT ALL Handset does not Ring When YOU Receive a CallCase of Difficulty No Dial ToneCommon Cure for Electronic Equipment YOU Hear Other Calls While Using Your PhoneBase does not Ring Your Caller Fades in and OUTWarranty Statement What does OUR Warranty not COVER? HOW does State LAW Relate to this WARRANTY?Canada Vtech Electronics FCC and IC RegulationsUnited States FCC PartIC Industry Canada This telephone is registered for use in CanadaOffice Power Requirements Technical SpecificationsTransmit Frequency Weight Receive FrequencyTable of Contents If Your Phone Rings During AN Intercom Conversation Issue 91-5073-10-00