VTech VT 9241 manual Replacing the Handset Battery

Page 5

REPLACING THE HANDSET BATTERY

1.Remove the battery case by press- ing on the ridged lines and sliding downward.

2.Discard the old Battery Pack. Don’t put the old Battery Pack in a trash compactor or a fire - it could burst.

IMPORTANT: Do not dispose of this battery in household gar- bage. For information on recy- cling or proper disposal, consult your local solid waste collection or disposal organization.

3.Place the new Battery Pack in the battery compartment. Make sure the metal contacts on the underside of the battery are aligned with charging contacts in the battery compartment.

cradle of the Base Unit to allow it to charge for 16 hours.

CAUTION: To reduce the Risk of Fire or Injury to Persons, Read and Follow these Instructions:

1.Use only VTECH battery.

2.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

3.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

4.Do not dispose of the battery in a fire. The cell may explode.

+ -

4.The new Battery Pack must be charged before using your tele- phone. Place the Handset in the

5

Image 5

Contents Introduction FeaturesWall Mounting Bracket Base Unit Battery pack Handset Belt clip AC adapterParts Check List Read and understand all instruc- tions Important Safety InstructionsRbrctm Seal If the product exhibits a distinct Change in performanceReplacing the Handset Battery To install the Spare Battery Pack Spare Battery ChargerCharge the Handset BATTER- IES Before USE. The batteries Getting StartedNever install telephone wiring dur- ing a lightning storm Wall Mounting Handset Features Power LED Base Unit FeaturesSpare Batt LED Charge LEDVolume Down KEY OFF KEY Volume UP KEYRinger Switches TONE/PULSE SwitchMaking Calls Operating InstructionsTips on Usingthe VT 9241 Speak Erphone Mute FeatureAnswer a Call To PUT a Call on HoldMaking or Answering a Call While YOU’RE Already on a Call Pressing the VOL UP or Down keysFerence Calling From the Base UnitJoining a Conversation Press Hold on the HandsetPress the appropriate Line key on the Base Unit Using the Intercom Temporary Tone Feature Using the Intercom During a Phone CallIf Your Phone Rings During AN Intercom Conversation Programming the Ringer TypeTo turn off the ringer on the Handset do the following Turning OFF the RingersPress PGM/MEM Checking the RingerTo Speed Dial a Stored Number To Store a Number Into MemoryTo Change or Replace a Stored Number Storing a Pause in a Speed Dial NumberConference Calling Using RedialStoring a Redial Number in Memory Speed Dial Switching a Conference Call From Base Unit To Handset Switching a Conference Call From Handset To Base UnitWay Conference Calling Ending One Side Or Entire Confer- ence CallChanging Channels Installation Optional Headset Installation and Operating InstructionsONE Inch Data Port Excess water or cleaning solvents of any kind MaintenanceTaking Care of Your TELE- Phone Electrical StormsCase of Difficulty Handset does not Ring When YOU Receive a CallPhone DOESN’T Work AT ALL No Dial ToneBase does not Ring YOU Hear Other Calls While Using Your PhoneCommon Cure for Electronic Equipment Your Caller Fades in and OUTWarranty Statement HOW does State LAW Relate to this WARRANTY? What does OUR Warranty not COVER?United States FCC and IC RegulationsCanada Vtech Electronics FCC PartThis telephone is registered for use in Canada IC Industry CanadaOffice Transmit Frequency Weight Technical SpecificationsPower Requirements Receive FrequencyTable of Contents If Your Phone Rings During AN Intercom Conversation 91-5073-10-00 Issue