Nortel Networks 3100 manual Before you begin, System and network requirements

Introduction

•Use the following call modes:

—Direct Outbound—This is the basic mode. You can initiate calls directly from your Nokia device to other parties by dialing or selecting friends to call. This direct mode uses an Outgoing Call Service DN to access the MCG 3100 in the enterprise. The MCG 3100 then dials the number entered in the MCC 3100 using the enterprise dial plan.

—Call-me-First—This is a call option in the advanced mode, and you can change many other calling options (for example, outgoing prefix, calling locations). Call-me-First calls take two steps to complete. First, the MCG 3100 calls you at a chosen location. After you answer, the MCG 3100 initiates the call by calling the number you entered in the MCC 3100 using the enterprise dial plan.

For more information, see “Call modes” on page 49.

Note: You must configure your Outgoing Call Service DN in the MCC 3100 settings before you can use the Direct Outbound call mode. Your system administrator provides the Outgoing Call Service DN to allow direct MCC 3100 calling from your Nokia device.

For more information, see “Initial configuration” on page 23.

Before you begin

Before you install the MCC 3100 application, complete the following checklist:

•Install the Nokia PC Suite software and ensure it is working properly.

•Become familiar with navigation and data entry methods for your Nokia device.

System and network requirements

The MCC 3100 for Nokia has the following system requirements.

12