AT&T 955 user manual Wall Installation

Page 7

INSTALLATION

3Connect the handset cord.

Plug one end of the coiled handset cord into the jack on the left side of the phone. Plug the other end into the handset, and hang up.

4Connect the power adapter.

Use only the power adapter provided with this product. To obtain a replacement, call 1 800 222–3111.

Plug one end of the power adapter into the jack labeled ADAPTER on the back of the phone. Plug the other end into a standard electrical outlet not controlled by a wall switch.

NOTE: If the screen displays POWERFAIL the first time you plug in the phone, press any key to clear the screen.

5Check for dial tone.

Lift the handset and listen for a dial tone. If you cannot hear a dial tone, turn to IN CASE OF DIFFICULTY.

6Initialization.

As soon as you connect the power cord, the system runs a quick self-test and the screen displays Initializing for about seven seconds. When the test is complete, the system enters an initial setup mode (this happens the first time you plug in the unit only) and the screen displays press PROG to setup your phone. See SET UP SYSTEM FEATURES beginning on page 15.

Wall Installation

1Reverse the handset tab.

Hold down the switchhook, then pull the tab out and rotate it

180 degrees. Push the tab down into the grooves so it settles into position.

INSTALLATION

2Install one 9V battery.

Press in on the tabs and remove the telephone base.

Use a small Phillips head screwdriver to remove the screw and open the battery door.

Insert the 9V battery (included), and replace the screw to close the battery door.

Replace the telephone base.

NOTE: The battery retains telephone memory in the event of a power failure. If power fails and a working battery is installed, this phone will work only to dial and answer calls with the handset or headset. No other features will work until power is restored.

3Connect the telephone line cords to the telephone. Please refer to line cord connection instructions in Step 2 of “Table/Desk Installation” on page 9.

4Turn the base, as shown, and attach it to the bottom of the phone.

10

11

Image 7
Contents Part 1 Important Product Information Four-Line Intercom SpeakerphoneContents Before YOU Begin ContentsGlossary Audible Signals Features ListConnect the telephone line cords to the telephone InstallationTable/Desk Installation Install one 9V batteryWall Installation Plug one end of the coiled handset cord into the jack on Connect the power adapter to the telephoneMount the phone on the wall Convenience Ports SET UP System FeaturesAssign an Extension Number to Your Phone Turn Covm Indicator On or Off for Each LineChange Display Language Set the Time/DateAssign the Prime Line Line Preference Set Delay RingSet the Dial Mode Turn Line Usage On or Off for Each LineProgram Home and Local Area Codes Program the Centrex Console Delayed Ring TimeErase All Settings and Return the Phone to Default Settings Turn Hold Reminder On or OffSpeakerphone Telephone OperationMaking or Answering a Call HandsetDo Not Disturb TimerVolume Call PrivacyHold Switch Between LinesRedial Auto RedialTransfer a Call Low Battery IndicatorTemporary Tone Dialing Conference CallsStoring a Name and a Number in a Speed Dial Location Speed Dial OperationRemoving Information from a Speed Dial Location Reviewing Information Stored in a Speed Dial LocationEditing Information Stored in a Speed Dial Location Making a Speed Dial CallStoring a Pause in a Directory Number Storing a Temporary Tone Signal in a Directory NumberDirectory Operation Storing Names and Numbers in the DirectoryChanging Directory Entries Reviewing Information Stored in the DirectoryDialing a Number from the Directory Removing All Entries from the Directory Removing a Name and Number from the DirectoryIntercom Operation Answering a System-wide Switching Between an Intercom Call and a Single-phoneEnding an Intercom or Page Call Paging All PhonesCaller ID Operation Caller ID OperationCalls Received on Two or More Lines Simultaneously Call WaitingMessage Waiting and NEW Call Light Display Messages Call ListRemoving Calls from Call List Time/Date Reset Covm IndicatorDialing a Number from Call List Saving a Number from Call List to the DirectoryAdding a FAX Machine Using a Fax SwitchCase of Difficulty No Caller ID Information While on a Call Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Covm Line Indicator Remains OnLine Groups Expanding the 955 SystemPrivate Lines Centrex Operation All Removed! 38 AM/PM Area CODEs 7 IndexTONE/PULSE 6 Page Four-Line Intercom Speakerphone Speed Dial Operation pages