System Time
Even though you enter the time in
Number of Lines
Code: #103
Description: The time, in
Valid Entries: Any time
Programming Notes: Enter the time in
Programming Steps:
1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 3 ]. The
display reads:
System Time
Data 0000
2.Enter a new time in
System Time
Data 1415
Code: #104
Description: Use this procedure as a quick way to assign the same number of outside lines to all extensions when first setting up the system. You can assign all or only some of the outside lines to all extensions. If you assign fewer lines than the total number of lines in the system, the system assigns the lines in order. For example, if you assign 5 lines but there are 8 outside lines, the sys- tem assigns lines 1 through 5 to all extensions.
Valid Entries: | 0 through 8 lines |
✔2 lines per 206 module installed
Considerations:
To add or delete specific lines on specific extensions, use procedure #301, Line Assignment.
If you later add more lines to the system, use procedure #301 to assign them to extensions rather than this procedure, which returns the Line Assignment (#301 ), Automatic Line Selection (p.
Programming Steps:
1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 0 ] [ 4 ]. The
display reads:
Number Of Lines
8Lines
2.Enter the correct number of lines. For example, to tell the system there are
7 outside lines, press [ 7 ] . The display reads:
Number Of Lines
7 Lines
System Programming