AT&T at&t partner plus communications system manual Toll Call Prefix System Password, Code #402

Toll Call Prefix

System Password

Entering the password allows you to override several dialing restric- tions. See appendix B for a sum- mary of dialing restrictions.

Code: #402

Description: Phone companies recognize long distance calls in either of two

ways: a telephone number preceded by 0 or 1 plus an area code or a tele- phone number preceded only by an area code. Use this procedure to tell the PARTNER Plus system which method your phone company uses.

Valid Entries: ✓ 1 = 0 or 1 plus the area code

2 = Area code only (0 or 1 not necessary)

Programming Steps:

1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The display reads:

Toll Call Prefix

1 0/1 + AreaCd

2.To change the toll call prefix, press [ Next Data ] until the appropriate setting appears. For example,

Toll Call Prefix

2 Area Code Only

Code: #403

Description: Identifies the 4-digit password that lets a user override Outgoing Call Restrictions (#401). You can also use the password with Night Service (#503 and #504) to restrict after-hours dialing.

Valid Entries: Any 4 digits

Considerations: If you assign a password using this procedure, you must enter the password when-turning Night Service (#503) on or off.

Programming Steps:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The display reads:

Set Password

Data----

If a password has previously been set, it will appear on the display.

2.Enter or change the password using the dial pad. For example, to set the password to 5747, press [ 5 ] [ 7 ] [ 4 ] [ 7 ] . The display reads:

Set Password

Data5747

To remove a password, press [ Remove ]

✓ = Factory Setting

To go to the next procedure: [ Next Proc ]		Togo to a specific procedure: #[ ] [ x ] [ x ] [ x ]
To go to the previous procedure: [Prev Proc ]		(where XXX is the procedure number)
To return data to the factory setting: Remove[	]	To exit system programming: [Feature ] [ 0 ] [ 0 ]

System Programming 3-19