General Instructions
Remember to place the program- ming overlay on the dial pad of extension 10 before starting.
When you go to another pro- cedure, start with step 2 of the instructions for the new pro- cedure.
You can also exit program mode by lifting and replacing the handset, or by replacing it if it has been lifted.
Programming the PARTNER Plus system requires no complicated steps or intensive training. By following the detailed instructions given in the rest of this chapter, you can quickly change system settings. As you become familiar with programming, use the Programming Quick Reference on the inside back cover of this guide for procedure codes and settings.
The detailed instructions for each procedure include:
■A brief description of the procedure
■Valid data entries or procedure settings
■Considerations for how the procedure interacts with other procedures (if appropriate)
■Programming notes and steps including:
■Entering system program mode
■Selecting the procedure
■Selecting items— lines, extensions, list, and phone
■Entering data
The instructions use the initial factory setting (designated with an ✔ in the valid entries section). if your system has been previously programmed, the displays may differ.
Once you’ve completed the steps in the detailed instructions, the data setting is saved. You can now
■go to another procedure,
■return the data to the factory setting, or
■exit program mode.
Instructions for these choices are given in the box shown on the bottom of every two pages:
✔ = Factory Setting
To go to the next procedure: [ Next Proc ] | To go to a specific procedure: [ # ] [ x ] [ x ] [ x ] [ x ] | ||
To go to the previous procedure: [ Prev Proc ] | (where XXX is the procedure number) | ||
To return data to the factory setting: [ Remove ] | To exit system programming:[ Feature ] [ 0 ] [ 0 ] | ||
|
|
| |
System Programming