AT&T at&t partner plus communications system Night Service Button, Code #503, Programming Notes

Night Service Button

Night Service is useful if you want all phones to ring after hours.

For example, the Shipping Department does not answer calls during the day, but after hours you want them to answer incoming calls.

Night Service with a System Password is useful for controlling unauthorized use of phones after hours.

Code: #503

Description: To use the Night Service feature, you must program it onto the PARTNER display phone at extension 10. This procedure automatically assigns Night Service to the second programmable feature button with lights:

To turn Night Service on and off, simply press this button. When Night Service is on, all lines ring immediately, regardless of their normal Line Ringing Options (see p. 4-4).Night Service affects only the extensions in the Night Service Group. Use procedure #504 to setup the Night Service Group.

Valid Entries: 1 = Night Service assigned

✓2 = Night Service not assigned

Considerations: If you program a System Password (#403) as well as Night Service, the password must be entered when turning Night Service on or off. In addition, when Night Service is on, users in the Night Service Group can dial only Emergency Numbers (#406) and Marked System Speed Dial Numbers (p. 3-34) without entering the System Password.

Programming Notes:

■This procedure erases any feature or Auto Dial number you may have previ- ously programmed onto the Night Service button.

■If Night Service is assigned, you cannot program another feature on this but- ton, unless you remove Night Service first.

■A Night Service button can be programmed only for extension 10.

Programming Steps:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 5 ] [ 0 ] [ 3 ]. The display reads:

Night Service

2 Not Assigned

2.To program Night Service onto the Night Service button, press [ Next Data ] until the display reads:

Night Service

1Assigned-Ext10

3.Label the Night Service button on extension 10.

✓= Factory Setting

To go to the next procedure: [ Next Proc ]		To go to a specific procedure: [# ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]		(where XX X is the procedure number)
To return data to the factory setting: Remove[	]	To exit system programming: [Feature ] [ 0 ] [ 0 ]

System Programming 3-27