Eurotech Appliances 01.06 A, Multi-Cell PRI Gateway Overlap, Block, ∙ Incoming Min. Digits Number

EEPROM containing ISM software. Enter the ISM version in the ISM version box.

3.Set Network access as NT, (set the switching unit as TE).

4.Define the Master/Slave status in the Synchronization box. It is preferable to define the Multi-Cell unit as the Master, and the switching unit as the slave.

5.In the Incoming Calls box, select the interface of incoming calls (from the switching unit to

the ISDN card), Overlap (pulse) or In Block (packet) in conformity withthe setting in the switching unit.

∙	If	Overlap	is selected, then proceed to step 6. Do not place entries in the last
	two parameters
∙	If	In Block	is selected, then place entries in the ring signal parameter

∙Incoming Min. Digits Number

This parameter determines when a ring signal will be initiated in calls coming from switching box, to the ISDN card. Enter the minimum number of digits of incoming phone numbers in this box (for example 050 787-444 = 10 digits).

∙Outgo the Max. Digits Number

This parameter determines when a ring signal will be initiated in calls coming from the ISDN card, to the switching box. Enter the minimum number of digits of incoming phone numbers in this box (for example 6001 = 4 digits).

6.In the Type of Number box, select the type of number (TON) of calls (from the ISDN card to the switching unit), as defined in the switching unit.

7.The protocol of numbers (from the ISDN card to the switching unit) is set at Number Plan Identification (NPI). Set this parameter as defined in the switching unit.

8.Each Multi-Cell has a part number. Enter the part number of your Multi-Cell in the

Local number box.

9.If you have more than one Multi-Cell on site, enter the sub address of each Multi-Cell unit in the Local sub address box.

10.Press Write ISDN Setting button to send the ISDN settings to the Multi-Cell unit.

PRI – GSM Multi-Cell Gateway 26