Polycom E340, H340, I640, 72-1065-09 manual Startup Sequence, Audio features, Line indicators

SpectraLink Corporation	Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
	NetLink Telephony Gateway and SpectraLink Radio Protocol

handset will follow the protocol command provided by the PBX if the user selects PBX cadence described in section 3.2 User-defined Preferences.

Audio features

Speaker-phone features are not available on the handset unless using the NetLink Docking Station.

Line indicators

The Line Indicator bullets on the handset will convert to a solid or flashing number to mimic the Line LEDs on the deskset, based on the assignment made at the PBX.

2.6Startup Sequence

The handset goes through an initialization sequence at startup. The line icons 1 through 9 display and count down as the handset steps through this sequence. This is usually very rapid. If there is any difficulty at any step that prevents initialization from continuing, an error message will display and the related icon(s) will stay on. Please see the Handset Status Messages table at the back of this document for instructions on how to handle error messages that occur during initialization.

Icon	The icon(s) shown in bold turns off when:
123456789	The handset has located and authenticated and associated with at least one AP, and is proceeding to
	bring up higher-layer networking functions.
12345678	The handset is either configured for Static IP, or if configured for DHCP the DHCP discovery process
	has started.
1234567	If DHCP is configured, a DHCP response was received which contains a good DNS server
	configuration.
123456	Note: Only valid on non-SRP protocol. Indicates one of the following:
	Static IP configuration, or
	SVP Server address found in DHCP response, or
	SVP Server address found via DNS lookup.
12345	All networking functions are complete (notably, DHCP) and the handset is proceeding with
	establishing the SRP link to the NetLink Telephony Gateway.
1234	The SRP link is established, all network stack initialization is complete, proceeding with application-
	specific initialization.
123	The link between the handset and the NetLink Telephony Gateway is established.
(no icons)	Initialization is complete. The handset is in standby mode ready to receive and place calls.
EXT. XXX

PN: 72-1065-09-J.doc Page 10