Panasonic KX-TG2970 operating instructions FCC and Other Information

Page 80

FCC and Other Information

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, for repair or warranty information, please contact a Factory Servicenter or other Authorized Servicer. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.

WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS:

1)Remain on the line and briefly explain to the dispatcher the reason for the call.

2)Perform such activities in the off-peak hours, such as early morning or late evenings.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Privacy of communications may not be ensured when using this phone.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR. This will often reduce, or eliminate, interference.

80

Image 80
Contents Model No. KX-TG2970 Pulse-or-tone dialing capability Charge the battery for 6 hours before initial useGHz Expandable Cordless Answering System Copyright Accessories includedAttach your purchase receipt here Battery Charge For Best PerformanceBase Unit Location/Noise TrademarksContents Contents Location of Controls Base unitLocation of Controls Cordless handsetCharger unit Conf Conference/FUNCTIONHow to use the navigator keys/soft keys Lighted handset keypadNavigator keys Cordless handset soft keysBacklit LCD displays DisplaysBase unit Cordless handset Installation ConnectionsTo replace the battery InstallationInstalling the Battery in the Cordless Handset Installation Battery Charge Battery strengthDisplay prompt Battery strength RechargeOperation Operating time Battery informationBattery replacement Programmable Settings How to select a function item from the menuTelephone Programming Guidelines Base Unit HandsetUseful information Programmable SettingsTone Programmable Settings Function Menu Table Remote code Call monitoring pTo the ADT security services Programmable Settings Date and Time Base Unit For Caller ID service users pTelephone Date and timeSet dial mode Set line mode Then press Scroll to Set line mode by pressingOr , then press Scroll to Set tel line by pressing or Or , then press Select a or B by pressing orOff ? Ringer settingRinger volume Programmable Settings Ringer Tone Handset Or , then press Scroll to Ringer tone by pressing orThen press Select the desired tone by pressing or Press the soft key Save , then press OFFProgrammable Settings Auto Talk Handset LowPreparing the Answering System Greeting Message Base UnitTo record a greeting message To review the greeting3min Preparing the Answering SystemCaller’s Recording Time Base Unit Pre-recorded greetingToll saver Preparing the Answering System Number of Rings Base UnitSelect the number of rings by pressing or Registration for Additional Handsets Base Unit & Handset KX-TG2970Using the Base Unit Base Unit To adjust the handset/speaker volume during a conversationMaking Calls To have a hands-free phone conversation3334444 Making CallsTo dial after confirming the entered number To redial the last number dialedMaking Calls Using the Cordless Handset Handset To adjust the receiver/speaker volume while talkingTo redial using the redial list Memory Redial Clarity Booster featureAnswering Calls Auto TalkCaller ID Service Display MeaningUsing the Caller List Viewing the Caller List Base Unit HandsetPress or to enter the Caller List What √ meansTURNER,CINDY Scroll to the desired caller by pressing orScroll to the desired caller by pressing Press the soft keyTo call the edited number Base unit Lift the handset or press Digital SP-PHONETo turn on or off Caller ID Number Auto Edit feature Caller ID editOr , then press Scroll to Caller ID edit by pressing Or , then press Select Off or On by pressing orBase Unit Handset Press againOFF To erase a specific caller To erase all entriesAgain Phone Book Tom5557654321 Storing Names and Numbers Base Unit HandsetPhone Book Selecting characters to enter namesIf you make a mistake while entering a name or number For example, to enter TomFrank Phone Book Dialing from the Phone Book Base Unit HandsetTo search for a name by initial Index table Keys555 Jane456-7890 To copy one phone book item to another unit CompletePhone Book Copying Items in the Phone Book Handset To copy all of the items in your phone book to another unit Copy all itemsOr , then press Scroll to Copy all items by pressing Or , then press Select the destination extension number byIntercom Calling BaseMaking Intercom Calls Press LOCATOR/INTERCOM/TRANSFERIntercom Answering Intercom CallsPress , or Hold Intercom During an intercom callTransferring a Call Base Unit Handset From the base unit to the cordless handsetFrom the cordless handset to the base unit From a cordless handset to another cordless handsetTo complete the transfer, press OFF Transferring a CallQuick call transfer Conference Calls Call ShareTo join a conversation Call Share Base Unit Handset During a call, press Hold IntercomSpecial Features For Call Waiting Service Users Base Unit HandsetMuting Your Conversation Base Unit Handset Temporary Tone DialingSpecial Features Incoming Call Tone Base Unit HandsetIncoming call Or , then press Scroll to Incoming call by pressingSelecting the flash time use either Base Unit or Handset Set flash time700ms Then press Scroll to Set flash time by pressingPress Answer on to turn on the Answering System Setting the Unit to Answer Calls Base UnitAutomatic Answering Operation To turn the Call Monitoring feature off on the base unit To turn this feature on, select On in stepAutomatic Answering Operation Monitoring incoming callsPress Playback Listening to MessagesTo play back messages Received calls To end remote operation, press OFFVoice menu To turn the Answering System onListening to Messages During playbackErasing all messages Erasing MessagesErasing a specific message Interrupting remote operation Press Hold TransferPress 9 to hang up the call Remote Operation from a Touch Tone Phone Summary of remote operationOr , then press Scroll to Remote code by pressing or Enter a 2-digit remote codePress Save Press Stop To check the remote code, repeat steps 1 toRemote Operation from a Touch Tone Phone Voice Menu AnsweringSkipping the greeting Direct commandsTurning on the Answering System Connecting an optional headset Belt ClipOptional Headset To attach the belt clip To remove the belt clipWall Mounting Pull down the handset hook until it locks, soTab holds the handset Wall Template for the Charger unitWall Mounting Deregistration Canceling Registration/Re-registrationCanceling the Handset Registration Handset Telephone If the Following Appear on Your Display BusyInvalid Phone book fullIf the Following Appear on Your Display LaterSECURITYinactive RegisteredTelephone System TroubleshootingProblem Cause & Remedy Troubleshooting SP-PHONE, orTroubleshooting Answering System General Charge for 6 HRSImportant Safety Instructions Important Safety Instructions FCC and Other InformationFCC and Other Information FCC RF Exposure Warning Index Caller ID Number auto editIndex Transferring a callSpecifications Energy StarPage Page Panasonic Limitation For your future reference For product serviceWhen you ship the product