Programming
Changing the handset name
Each handset can be given a customised name (“Bob”, “Kitchen”, etc.). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. The default setting is “No”. If you
select “Yes” without entering any
handset name, “Handset 1” to “Handset 6” is displayed.
1MMENUN#104
2Enter the desired name (max. 10 characters; see the character table, page 26).
R If not required, go to step 3.
3MSAVEN
4MbN: Select the desired setting. a MSELECTN 2 times
5MOFFN
Incoming call barring (Caller ID subscribers only)
This feature allows the unit to reject calls when the unit receives a call from a phone number stored in the call barred list as unwanted (“Storing unwanted callers”, page 37).
When a call is received, the unit rings for a short time while the caller is being identified. If the phone number matches an entry in the call barred list:
–cellular calls are rejected.
–landline calls are disconnected after the unit first sends out a busy tone to the caller.
Important:
R When the unit receives a call from a number that is stored in the call barred list, the call is logged in the
caller list (page 42) with 
after the
call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the call barred list.
Important:
R You must store the phone number with an area code in the call barred list.
n From the caller list:
1MFN CID
2MbN: Select the entry to be barred.
3 MSAVEN
4MbN: “Caller barred” a
MSELECTN
5MbN: “Yes” a MSELECTN
6Edit the phone number if necessary (24 digits max.).
7MSAVEN a MOFFN
n By entering phone numbers:
1MMENUN#217 a MADDN
2Enter the phone number (24 digits max.).
R To erase a digit, press
MCLEARN.
3MSAVEN a MOFFN
Viewing/editing/erasing bar call numbers
1MMENUN#217
2MbN: Select the desired entry. R To exit, press MOFFN.
3To edit a number:
MEDITN a Edit the phone number. a MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a MSELECTN a MOFFN
Note:
R When editing, press the desired dial key to add, MCLEARN to erase.
37