Programming
Changing the unit’s region setting/Resetting the base unit
Important:
R When you install the batteries for the
first time, the handset may prompt you to set region setting. First press MSELECTN, then proceed to step 2.
1MMENUN#136
2MbN: Select the desired country. a
MSELECTN
“Australia” = Australia
“Newzealand” = New Zealand
3MbN: “Yes” a MSELECTN a MOFFN
Note:
R The following items will be deleted or reset to their default settings:
–Answering system settings (page 29)
–Time adjustment
–Base unit ringer volume
–Landline area code
–Line mode
–Privacy mode
–Bluetooth settings (page 32)
–Group ringer tone
–Talking Caller ID (Base unit setting only)
–Caller list
–Voice mail messages and access number
–Cellular phones settings (Base unit setting only) (page 31)
R The following items will be retained:
–Date and time
–Shared phonebook
–Handset name
–Repeater mode
–Recordings, including your greeting message, and caller messages
–Call screening
–Call barred list
–Cellular phones registration
–Headset registration
R If you select the desired country in step 2, the following default setting will be changed for the selected country’s default setting:
– Recall time (page 34)
R After changing the unit’s region setting/resetting the base unit, 
is displayed on the handset momentarily. This is normal and the handset can be used once 
is displayed.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Important:
R See page 5 for information on the available model.
Registering a handset to the base unit
The supplied handset and base unit are
1Handset:
MMENUN#130
2Base unit:
Press and hold MLOCATORN for about 5 seconds until the registration tone sounds.
R If all registered handsets start ringing, press MLOCATORN again to stop, then repeat this step.
R The next step must be completed within 90 seconds.
3Handset:
Press MOKN, then wait until a long beep sounds.
38