Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Important:
L The additional handset model recommended for use with this unit is noted on page 6. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.
L Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call.
Registering a handset to the base unit
The supplied handset and base unit are
1{j/OK}
2{^}/{V}: “Handset Setup” i
{>}
3{^}/{V}: “Registration” i {>}
4{^}/{V}: “Register H.set” i
{>}
5Proceed with the operation for your model.
■
Press and hold {x} on the base unit for about 5 seconds. (No registration tone)
■
L If all registered handsets start ringing, press {x} to stop, then repeat this step.
LAfter pressing {x}, the rest of this procedure must be completed within 90 seconds.
6Wait until “Enter Base PIN” is displayed. i Enter the base unit PIN (default: “0000”). i {j/OK} L If you forget your PIN, see page
39.
L When the handset has been registered successfully, w will stop flashing. If the key tone is turned on (page 19), a confirmation tone will be heard.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1{j/OK}
2{^}/{V}: “Base Unit Setup” i
{>}
3Enter “335”.
4{^}/{V}: “Deregistration” i
{>}
L The numbers of all handsets registered to the base unit are displayed.