Panasonic TG7200-7220E operating instructions Troubleshooting, Telephone Problem Cause & solution

Page 37

TG7200-7220E(e).book Page 37 Tuesday, May 22, 2007 9:34 AM

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit AC adaptor and turn off the handset, then reconnect the base unit AC adaptor and turn on the handset.

Telephone

Problem	Cause & solution
w is flashing.	L The handset is not registered to the base unit.
	Register it (page 30).
	L The handset is too far from the base unit. Move
	closer.
	L The base unit AC adaptor is not connected. Check
	the connections.
	L You are using the handset or base unit in an area
	with high electrical interference. Place the handset
	and base unit away from interference sources,
	such as antennas and mobile phones.
The handset display is	L The handset is not turned on. Turn the power on
blank.	(page 13).
The handset will not	L Make sure that the batteries are installed correctly
turn on.	(page 11).
	L Fully charge the batteries (page 12).
	L Clean the charge contacts and charge again
	(page 12).
I have changed the	L Change the display language (page 13).
display language to a
language I cannot
read.

			Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333				37

Image 37

Contents KX-TG7202E KX-TG7203E Base Unit Settings Handset SettingsCaller ID Service Answering System FeaturesDeclaration of Conformity Contact IntroductionHelpline Tel. No. U.K 844 3898 R.O.I Your phone Supplied accessories Accessory informationModel No Description Additional/replacement accessoriesImportant information Battery cautionGeneral EnvironmentFor business users in the European Union Charge contact ControlsConnections DisplaysCharger KX-TG7202/KX-TG7203/ KX-TG7222/KX-TG7223/KX-TG7224 Battery installation and replacementBattery level Battery icon Battery chargeBase unit*1 Setting up the unit before use Turning the power on/offDisplay language Date and timeTG7200-7220Ee.book Page 14 Tuesday, May 22, 2007 934 AM Pause for PBX/long distance service users Making a call using the redial listMaking calls Answering callsUseful features during a call Adding entries Handset phonebookFinding and calling a handset phonebook entry Editing entriesChain dial Handset settings Alarm KX-TG7220/ KX-TG7222/KX-TG7223/ KX-TG7224 Special instructions for time settingsTo customise the base unit using the handset Base unit settingsCall Options Recall/Flash Other OptionsCaller list Using Caller ID serviceViewing the caller list and calling back Editing a caller’s phone number before calling backErasing caller information Voice mail serviceStoring caller information into the handset phonebook Erase or Erase AllTurning the answering system on/off Answering systemGreeting message Playing back the greeting message Listening to messagesErasing the greeting message Listening to new/all messagesRemote operation Direct command operation using the handsetErasing all messages Calling back Caller ID subscribers onlyRemote commands Using the answering system remotelyTurning remote operation on Voice guidanceTurning on the answering system remotely Answering system settingsNumber of rings Call screening Caller’s recording timeRecording Time Call ScreeningRegistering a handset to the base unit Operating additional unitsAdditional handsets Deregistering a handsetBase Unit Setup Other Options Repeater Mode Setting the repeater modeIntercom between handsets Transferring calls between handsetsEntries Copying phonebookConference calls Copying all entries When the unit displays the character entry screen Characters available in each character entry modeCharacter entry Character entry modesExtended 2 character table O Extended 1 character table NError messages Telephone Problem Cause & solution TroubleshootingProblem Cause & solution Base Unit Setup Other Options Base Unit PIN For DSL users Specifications Panasonic Business Systems U.K Conditions of guaranteeIndex PQQX16063ZA CC0407DS1057 Sales and support information