Panasonic K10059 manual Arming the System Setting the Night-Stay mode

SecurityPhone.book 10 ページ ２００４年７月２１日 水曜日 午後６時５８分

Arming the System

Setting the Night-Stay mode

When you want to get more increased security than the Stay mode, select this mode.

When you set the Night-Stay mode,

—the perimeter zones and pre-selected interior sensors (programmed by your installer) are armed, and

—if the protected perimeter windows and doors are opened or interior zones are violated, an alarm sounds immediately.

Base Unit

1Press [ADT].

2	Press [g] at “ARM”.
		gARM
3	Scroll to “Night-Stay” by pressing [d] or
		gNight-Stay
	[B], then press [g].
4	Enter your security code.
		ENTER CODE
	• If you entered the wrong security code, the phone	----
	will go back to the previous display. Try again from	Example
	step 2.	;;;NIGHT-STAY;;;
	• The armed NIGHT-STAY message is displayed.	You may exit now

5Press [STOP] to go to the standby mode.

Handset : Press the soft key ( ADT ), and follow steps 2 to 4 above, using the cordless handset. Press [OFF] to go to the standby mode.

• To exit the menu, press [STOP] or [OFF].

To confirm the security mode you set, press [ADT] in the standby mode.

IMPORTANT:

When the Night-Stay mode is on, the selected interior zones are armed and cause an alarm if anyone enters those areas (e.g., waking in the middle of the night). To avoid sounding an alarm, you must disarm the system before any activity takes place in those interior zones

10