SecurityPhone.book 22 ページ ２００４年７月２１日 水曜日 午後６時５８分
Remote Phone Control
You can access the security system from a touch tone phone located off the premises. You can regain system status information over the telephone by voice guidance, control your security system by entering function commands remotely with the telephone dialing buttons.
To use this feature, you must program your own remote code*1. The factory preset remote code is “11”.
Summary of remote operation
Call your unit from a touch tone phone.
u
Enter your remote code during or after the greeting message.
•“Enter [1] to select Answering System*1 or [2] to select Security” is heard.
u
Press [2] to operate the security system.
u
The current security status will be announced, then the voice menu will start. Follow the voice menu or enter direct commands.**2
“To disarm, enter security code and [1].” “To arm stay, enter security code and [3].” “To arm away, enter security code and [2].”
• If you want to repeat the status and voice menu, press [#] [0].
u
To end remote operation, hang up or press [#] [9].
*1 See “Remote Operation from a Touch Tone Phone” in the Operating Instructions for
**2 You can also operate the security system by entering your security code and direct commands from a touch tone phone. Please confirm with your installer or refer to the corresponding pages in the 3000EN Security Systems User’s Guide.
•If you do not press any buttons within 15 seconds after a voice prompt, the call will be disconnected.
•If the “Greeting only” message is heard and beeps sound after entering remote code, the security system detects an alarm status.
You can enter your security code and direct commands to operate the security system.
22