Preparation
IP/TEL line selection
The line selection mode determines the line selected when you press {s} to make a call.
–“IP”: IP line is selected.
–“TEL” (default): Landline is selected. If you dial a Anumber (page 4) then press {s} using the handset, the IP line is automatically selected.
Note:
L You can select a line manually regardless of the line selection mode by pressing {TEL} or {IP}.
Handset line selection N
1{MENU} i{#}{2}{5}{0}
2{V}/{^}: Select the desired setting.
3{SAVE} i{OFF}
Note:
LWhen you press {CALL} to make a call (page 31), the set line is selected. When you call back from the redial list or caller list, the line indicated by V (landline) or j(IP line) is selected (page 31, 46, 60).
Base unit line selection N
Available model:
1{MENU} i{#}{*}{2}{5}{0}
2{V}/{^}: Select the desired setting.
3{SAVE} i{OFF}
Configuring the Internet connection settings
If your local network uses a DHCP (Dynamic Host Configuration Protocol) server for automatic IP address assignments, you do not need to change any settings. If your local network uses a static IP address, turn the DHCP connection mode off.
Leaving the DHCP connection mode on allows the base unit to receive an IP address automatically from a DHCP server on your local network.
Automatic setup (default) N
The base unit automatically obtains an IP address and other Internet connection settings (subnet mask, default gateway, and DNS server addresses).
Turning the DHCP connection mode on:
1{MENU} i{#}{5}{0}{0}
2{V}/{^}: “On”
3{SAVE} i{OFF}
L Wait until the STATUS indicator on the base unit turns green. When the STATUS indicator lights in green, the setting is complete. Confirm your A number (page 30).
L When the STATUS indicator does not light in green even if you wait for a few minutes, see page 23.
Note:
L To view the Internet connection settings:
{MENU} i{#}{5}{0}{1} i When finished, press {OFF}.
28For product assistance, visit www.globarange.com
For Aassistance, visit www.joip.com