Programming
Setting the flash time kN
The flash time depends on your telephone exchange or host PBX. Consult your PBX supplier if necessary. The default setting is “700ms”.
1{MENU} i{#}{1}{2}{1}
2{V}/{^}: Select the desired setting. i{SAVE} i{OFF}
Updating the base unit software N
Amay offer new features and improve its software version from time to time. If you set the base unit software update setting to manual mode at www.joip.com, you need to download the update when “Update version. Press OK.” is displayed on the handset.
Important:
L Make sure the STATUS indicator is lit in green and the IP indicator is not lit on the base unit.
1Press {OK} while “Update version. Press OK.” is displayed. L The current and new base unit software versions are displayed.
L If you want to download the update later, press {CANCEL}. When you are ready to download, see “Confirming the base unit software version”, page 56.
2{OK}
Note:
L The IP indicator and STATUS indicator on the base unit flash while downloading. When the download is complete, the IP indicator goes out while the STATUS indicator stops flashing and changes to steady green.
Confirming the base unit software version
1{MENU} i{#}{7}{2}{4}
L The current base unit software version is displayed.
2If “Update version?” is displayed, press {OK} to download. If not, press
{CANCEL}.
Adjusting the base unit ringer volume (BB-GT1540) f
1Press {IP/TEL} repeatedly until the display shows the desired line (nor m).
L You cannot set the ringer volume for both lines at the same time.
2Press {^} or {V} repeatedly to select the desired volume.
L To turn the ringer off, press and hold {V} until the unit beeps. L To stop ringing, press {STOP}.
56For product assistance, visit www.globarange.com
For Aassistance, visit www.joip.com