Maxon Telecom SP-200K Series operating instructions II. Safety Information

Page 5

I. FCC RF Exposure Compliance Requirements for Occupational Use Only

The Federal Communications Commission (FCC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated equipment. Topaz3 / Maxon subscribes to the same safety standard for the use of its products. Proper operation of this radio will result in user exposure far below the Occupational Safety and Health Act (OSHA) and Federal Communications Commission limits.

CAUTION - DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded.

This radio is NOT approved for use by the general population in an uncontrolled environment. This radio is restricted to occupational use, work related operations only where radio operator must have the knowledge to control the user’s exposure conditions for satisfying the higher exposure limit allowed for occupational use.

When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away from your mouth.

This device has been approved for use, at a maximum duty factor of 50%, using the specific belt clip and leather belt-holster tested for body-worn SAR compliance. Other belt clips or body-worn accessories may not comply and should be avoided.

The radio is transmitting when the red LED on the front of the radio is illuminated. You can cause the radio to transmit by pressing the P-T-T bar on the radio.

These are required operating configurations for meeting FCC RF exposure compliance. Failure to observe these restrictions mean violation.

II. Safety Information

WARNING - DO NOT hold the radio in such a manner that the antenna is next to, or touching, exposed parts of the body, especially the face or eyes, while transmitting.

WARNING - DO NOT allow children to operate transmitter-equipped radio equipment.

CAUTION - DO NOT operate the radio near unshielded electrical blasting caps or in an explosive atmosphere, unless it is a type especially designed and qualified for such use.

CAUTION - DO NOT press and hold the transmit bar (P-T-T) when not actually wishing to transmit.

1

Image 5
Contents SP -200K Series Table of Contents Contenido Table des Matières II. Safety Information IV. About Topaz3 III. About Your SP-200K Series RadioUnpacking Information VI. SP-200K Series Features Not shown VII. Description of Radio ComponentsIX. Installing and Removing the Battery Pack VIII. Antenna InstallationXI. Battery Charging and Care Attaching and Removing the Belt ClipXII. SP-200K Series Operation Power On Volume Power OffChannel Select / Channel Group Scan To TransmitAt power-up, the radio will default to Selcall mode Keypad Lock / Function Lock XIII. Status Indicators and Audible Alert TonesTo Receive Normal Channel Scan XIV. Scan ModesPriority Channel Scan XV. Other Scanning FeaturesLook Back Scan Channel DeleteXVI. Scan List Edit Priority Channel Edit Key 1 Long Press = Press and Hold for 2 Seconds XVII. Possible Set-ups for the SP-200K SeriesKeypad Key 2 Long Press = Press and Hold for 2 Seconds XIX. FCC Licensing XVIII. Compatible SP-200K / SP-210K AccessoriesXXI. Software Copyrights XX. ServiceXXII. Maintenance XXIII. Product Warranty Requerimientos de Obediencia a la Exposición de RF del FCC Page III. Acerca de Su Radio Serie SP-200K II. Información Sobre SeguridadInformación para Desempacar IV. Acerca de Topaz3VI. Funciones de la Serie SP-200K No mostrados VII. Descripción de los Componentes del RadioIX. Cómo Instalar y Retirar el Paquete de las Batería VIII. Instalación de la AntenaAsegurar y Quitar el Clip de Cinturón XI. Cómo Cargar y Mantener la BateríaXI. Cómo Cargar y Mantener la Batería, continuación Encendido Volumen ApagadoXII. Funcionamiento de Serie SP-200K Cómo Cargar y Mantener la Batería, continuaciónEn el ciclo inicial, el radio omitirá el modo de Selcall XII. Funcionamiento de Serie SP-200K, continuaciónPara Transmitir Bloqueo de la Función / Bloqueo del Teclado Numérico Para Transmitir, continuaciónPara Recibir XIII. Indicadores de Estado y Tonos Audibles de Alerta Búsqueda Normal de Canales XIV. Modos de BúsquedaXV. Otras Funciones de Búsqueda XIV. Modos de Búsqueda, continuaciónBúsqueda Normal de Canales, continuación Buscar Canal PrioritarioCómo Borrar un Canal de la Lista de Búsqueda Mirar Atrás, continuaciónBúsqueda Ctcss / DCS Búsqueda TX NormalEditar Canal Prioritario XVI. Editar la Lista de BúsquedaEditar el Grupo de Canales Teclado Numérico XVI. Editar la Lista de Búsqueda, continuaciónEditar Canal Prioritario, continuación Clave 2 Presión Larga = Presione y Sostenga por Dos Segundos XX. Servicio XVIII. Accesorios Compatibles SP-200K / SP-210KXIX. Licencia de la FCC XXII. Mantenimiento XXI. Derechos de Autor del SozftwareXXIII. Declaración de Garantía Garantie de Produit Page III. Au Sujet de Votre Poste de Radio de la Série SP-200K II. Informations sur la SécuritéDéballage IV. Au Sujet de Topaz3VI. Caractéristiques des Appareils de la Série SP-200K Non-visible VII. Description des Composants de la RadioVIII. Montage de lAntenne IX. Installation et Retrait de la BatterieFixation et Retrait de lAttache du Poste sur la Ceinture XI. Charge et Entretien de la BatterieXI. Charge et Entretien de la Batterie suite Marche Volume ArrêtXII. Utilisation des Radios de la Série SP-200K Sélection des Canaux / Balayage dun Groupe de CanalTransmission XII. Utilisation des Radios de la Série SP-200K suiteSerrure du Bloc de Touches / Serrure de Fonction Transmission suiteRecevoir Statut Description XV. Autres Caractéristiques du Balayage XIV. Modes de BalayageBalayage de Canal Normal Balayage dun Canal PrioritaireEffacement des Canal Balayés Retour en Arrière suiteBalayage Ctcss / DCS Transmission TX Avec Balayage NormalXV. Autres Caractéristiques du Balayage suite Balayage sur le Mode Réception SeulementXVI. Édition de la Liste de Balayage Transmission TX Prioritaire SeulementÉdition dun Canal Prioritaire XVI. Édition de la Liste de Balayage suiteÉdition dun Groupe de Canal suite Clé 1 Longue Presse = Presse et Prise Pendant 2 Secondes XVII. Installations Possibles pour la Série de SP-200KBloc de Touches XVII. Installations Possibles pour la Série de SP-200K suite XIX. Licence par le FCC XVIII. Accessoires Compatibles de SP-200K / SP-210KXXII. Entretien XXI. Droits de Reproduction du LogicielXXIII. Garantie de produit XXIII. Garantie de produit suite Supplier of Maxon, Legacy and TruTalk Communication Products