Uniden EXA3955 manual Choose the dialing mode, Base Setting only

Page 11

D. Choose the dialing mode

Most phone systems use tone dialing, which sends DTMF tones through the phone lines. However, some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

Base Setting only

1	Press and hold flash/set until you hear a confirmation tone.
2	To set the dial mode for pulse dialing, press				# . Or to set the dial
	mode for tone dialing, press			. A confirmation tone sounds to

	indicate the setting is complete.

•If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.

•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may “switch-over” to tone dialing (refer to “Tone Dialing Switch-over” on page 22).

note

Make sure your battery pack is fully charged before choosing the dialing mode.

G E T T I N G S T A R T E D

G E T T I N G S TA R T E D [ 9 ]

Image 11

Contents Page Page Contents Explanation purposes FeaturesWelcome N T R O L S a N D F U N C T I O N S Controls and FunctionsFast Forward Key Play/Stop Key Rewind Key Checking the Package Contents Choose the best location Setting up the PhoneDo the following steps Low battery alert Install the battery packBattery use time per charge Connect the base unit Press and hold flash/set until you hear a confirmation tone Choose the dialing modeBase Setting only Standard wall plate mounting Setting the handset retainer clip for wall mountingDirect wall mounting Handset Off the Base Making and Receiving CallsFrom the Handset From the Base Handset On the BaseRedial Adjusting the Base RingerRinger tone and volume Earpiece volumeFlash and Call Waiting Traveling Out-of-RangeWith the Handset Storing Phone NumbersFrom the One-touch Priority Dial Making Calls with Memory DialingWith the Base From the Memory LocationPress talk key Erasing Stored NumbersWay Conferencing When speaking on the handsetWhen speaking on the base Base. The handset beeps. If no answer, press Intercom/Page FeatureIntercom from the base to the handset Intercom from the handset to baseTo transfer from the base to the handset Call Transfer FeatureTo transfer from the handset to the base Selecting a Different Channel Chain DialingMute Handset/Base Tone Dialing Switch-over Integrated Answering Device Turning the Answering System On/Off Setting up your Answering SystemUsing the Menu Mode Choosing between the two outgoing messages Setting Your Outgoing Message GreetingPreset message Recording a personal outgoing message GreetingTo select the minute Setting the TimeSetting a Personal Security Code You hear the current ringer option High Setting the base ringer volumeAdjusting the speaker volume level Four timesSetting the Ring Time Selecting the message record time Announce only featurePlaying your messages Using your Answering SystemSkipping a message Repeating a messageVoice memo Deleting a messageTo stop recording, press or memo/rec Remote access away from homeRecording a conversation Command You may select a command from the following chartTurn on the answering system remotely Changing the Digital Security Code To remove the Face plate To attach the Face plate Headset InstallationChanging the Face Plate Maintenance Installing the BeltclipPower Failure Battery replacement and handlingSymptom TroubleshootingSymptom Suggestion AC Adapter Information Battery InformationGeneral Information Precautions Installation Considerations G, H IndexRemote Operation Card Remote access away from homeTask Key At Uniden, we’ll take care of you