Troubleshooting
If your phone is not performing to your expectations, please try these simple steps first.
Symptom
The status LED won’t light when the handset is placed in the base unit.
The audio sounds weak and/or scratchy.
Can’t make or receive calls.
The handset doesn’t ring or receive a page.
Severe noise interference
Suggestion
•Make sure the AC adapter is plugged into the base unit and wall outlet.
•Make sure the handset is properly seated in the base unit.
•Make sure the charging contacts on the handset and base unit are clean.
•Press channel during a call to help eliminate background noise.
•Make sure that the base unit antenna is in a vertical position.
•Move the handset and/or base unit to a different location away from metal objects or appliances and try again.
•Make sure that you are not too far from the base.
•Check both ends of the base unit telephone line cord.
•Make sure the AC adapter is plugged into the base unit and wall outlet.
•Disconnect the AC adapter for a few minutes, then reconnect it.
•Reset the digital security code (See page 37).
•Make sure talk is pressed.
•The battery pack may be weak. Charge the battery on the base unit for 15 - 20 hours.
•The handset may be too far away from the base unit.
•Place the base unit away from appliances or metal objects.
•Reset the digital security code (See page 37).
•Keep the handset away from microwave ovens, computers, remote control toys, wireless microphones, alarm systems, intercoms, room monitors, fluorescent lights, and electrical appliances.
•Move to another location or turn off the source of interference.
ADDITIONAL INFORMATION
A D D I T I O N A L I N F O R M AT I O N [ 41 ]