Controls, TOP and Front Panel, Back Panel

CONTROLS

POWER SUPPLY

English

TOP AND FRONT PANEL

1Source selector - to select source of sound: CD-RADIO-TAPE and also the POWER OFF

switch.

2VOLUME - to adjust volume level.

3DBB - Dynamic Bass Boost: for a more vivid bass response.

CASSETTE RECORDER:

4PAUSE ; - to interrupt recording or playback. STOP•OPEN 9 / - To stop the tape and to open the cassette holder.

SEARCH 5 or 6 - to fast forward/rewind the tape.

PLAY 1 - to start playback.

RECORD 0 - to start recording.

5Cassette compartment

CD PLAYER:

6 CD Display - to show the CD functions.

7 PLAY•PAUSE 2; - To start or interrupt CD play.

STOP 9 - to stop playback or erase a program.

CD MODE - to select a different play mode. e.g. SHUFFLE/REPEAT; to program and review programmed track numbers

SEARCH ∞ or § - to skip or search a passage/ track backwards or forward

8LIFT TO OPEN - to open/ close the CD door

RADIO:

9 BAND - to select FM/AM wave band

0 Tuning dial pointer

! TUNING - to tune to radio stations

BACK PANEL

@Battery door - to open the battery compartment

#BEAT CUT switch - To eliminate any whistle tones during AM recordings.

$Telescopic antenna - to improve FM reception

%p - 3.5 mm stereo headphone jacket

Note: Connecting headphones will switch off the loudspeakers

^AC MAINS - inlet for mains cord

Batteries

Whenever convenient, use the mains supply if you want to conserve battery life. The battery supply will be switched off when the set is connected to the mains. Make sure you remove the plug from the set and wall outlet before inserting batteries.

Batteries (optional)

1.Open the battery compartment and insert six batteries, type R20, UM1 or D-cells (preferably alkaline) with the correct polarity as indicated by the (+) and (-) symbols inside the compartment.

2.Replace the compartment door, making sure the batteries are firmly and correctly in place. The set is now ready to operate.

–Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore:

–Do not mix battery types, e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

–When inserting new batteries, do not try to mix old batteries with the new ones.

–Remove the batteries if the set is not to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly

6x R20/UM 1/D-CELL