Tyco LPE-200 manual Message Operation, Dynamic Regroup Operation

pressed (the M key will override the time-out

period), the status is selected and will be transmitted to the site or stored in the radio memory where it can be polled by the site at a future time. Status messages can also be programmed for single key operation so that a single press of a key assigned to a status message automatically transmits that message. If the site does not receive the status properly, the radio will sound a low pitched tone.

The status selection can also be canceled by pressing the CLEAR button prior to the time-out period.

To view the currently selected status after it has been transmitted, press the M key and then the

<key to ramp to STS, re-press the Mkey again

and then the CLEAR button prior to the time-out period. If the status was not sent successfully to the site, the text associated with the status will flash in the display.

MESSAGE OPERATION

Message operation is performed in the same manner as status operation in previous paragraph.

DYNAMIC REGROUP OPERATION

Dynamic group operation permits multiple talk groups (up to eight) to be added to a radio via the system manager. The radio must be pre- programmed to respond to regrouping. Dynamic regrouping will not be activated in a radio until an

63